HDHD HD HD
Combined SPD- Type 1+2
Description
Circuit diagram
Dimension drawing
Features
Approval
UL 94 V-0
TUVCERoHS
This SPD Combination consisting of:
4 x PE 760-25W1-10R
1 x Busbar 7P-4
No follow currentReliable thermo disconnect deviceHigh discharge capacityCapable of protecting terminal equipment
Multifunctional terminals for connecting conductors and busbars
Visual and remote status indication
DIN rail installation
DIN Rail, for use in a.c. system at combined Type 1&2 /Class I&II SPD boundaries from LPZ 0B-1 and higher.
PTG CORPORATION
Vibration and shock testing veri�ed, EN60082-2 complianceDirectly coordinated with Type 2 or 3SPD without additional cable length, DIN CLC/TS 61643-12 compliance
PE 760-25W1-10R PE 760-25W1-10R PE 760-25W1-10R PE 760-25W1-10R
2 mm² stranded / �exible5
Type 1 + Type 2
Withstand
≤ 100 ns
2.5 kV
3.5 kV
760 Vac
1
PE 760-25W1-40R-B
25 kArms
400/690 Vac
25 kA
156.25 kJ / ohms12.5 As
≤ 250 AgL / gG
Type
Part No.
Electrical
SPD according to IEC 61643-1/11
SPD according to EN 61643-11
Number of ports
Technology
Nominal Voltage (UN)
Max. continuous operating voltage (UC)
Nominal discharge current (8/20 µs) (In)
Lightning impulse current (10/350 µs) (limp)
Charge (Q)
Follow current extinguishing capability (If I)
Voltage protection level (UP)
Voltage protection level for 5 kA (UP)
Response time (tA)
Max. overcurrent protection
Short-circuit withstand capability
Temporary overvoltage (TOV) (UT)
TOV characteristic
3 N*m
10 mm
35 mm DIN rail
150 mm × 144 mm × 72 mm
Changeover contact
125 Vac / 1 A
1.5 mm ²
7 mm
0.2 N*m
IP 20
≤ 95%(max 40°C)
Indoor only
Thermoplastic, UL 94 V-0
≤ 4 km
Mechanical
Method of mounting
Enclosure dimensions (HxWxD)
Cross-sectional area (max.)
Cross-sectional area (min.)
Stripping length terminals
Torque contacts
Indication
Operating status/fault indication
Type of Changeover contact
Switching capacity
Cross-sectional area (max.)
Stripping length for indication terminals
Torque contacts for indication terminals
Environmental
Location category
Operation temperature range (TU)
Relative humidity
Operation altitude
Degree of protection according to IEC/EN 60529
Enclosure material
-40°C ... +80°C
SPD according to GB 18802.1 Class I + Class II
(ISCW)
25 kA
1.5 mm² stranded / �exible
PE 760-25W1-40R-B
Class I + Class II
Infinite
Spark Gap&MOV
Specific energy (W/R)
PTG CORPORATION PTG-DS-EN-V1901
1000 V / 5 s
Black / red
93 40 90
Technical Data Connection Diagram Backup Fuse
Safety Instruction
The device may only be connected and installed by an electrically skilled person.National standards and safety regulations must be observed (see IEC 60364-5-53).The device must be checked for external damage before installation. The device must not beinstalled if any damage or other faults are detected in this check.Its use is only permitted within the limits shown and stated in these installation instructions. Thedevice and the equipment connected to it can be destroyed by loads exceeding the values stated.Opening or tampering with the device invalidates the warranty.
Maintenance info
INSTALLATION INSTRUCTION INS-E-760-25W1-40R-B-01A
@ COPYRIGHT 2018 PTG CORPORATION
CoordinationLPZ 0A LPZ 1 LPZ 2 LPZ 3
Class I + Class IIType 1 + Type 2PE XXX-XXW1-XXX
IEC 62305-4
IEC 61643-1/11EN 61643-11
F1
F2
F2 = 250 A gL / gG
F1 250 A gL / gG,
F2
F1 250 A gL / gG
IF
IF
max.
PE 760-25W1-40R-B
NC
COM
NO
Red ReplaceGreen OK;
max. 1.5 mm²6-7 mm
10-12 mm
Type934090No
Type of LV System TT,TNUo(UN)
LocationNumber of Ports
400/690 Vac(50/60 Hz)
1Indoor
Iimp(10/350 μs) 25 kA
T/H/A -40-85℃/<95%/4 kmA 3 NmB 35 mm DINrail (EN 60715)
L x H x W 150 mm x 144 mm x 72 mm
min. L, N, PEmax. L, N, PE
1.5 mm² 25 mm²
Fault Indication
Remote alarm terminalOnly for "R"
UN/IN 125 Vac/1 A;125 Vdc/0.2 A
In(8/20 μs)
Isccr/Ifi/IPE
25 kA
25 kA/-/-250 A gL/gG
min S1 16 mm² Cu
0.2 Nm
W/R 156.25 k J/ohms
F2
S1
MEB
F1L1L2L3NPE
ALARM
B
A
PTG CORPORATIONAddress: 3F, Mingdao Building, SGETechnology Park, #28 Cuibao Road, Long Gang District, Shenzhen, China
Tel: +86 755 2150 4406Fax: +86 755 2941 5700www.ptgcorporation.com
NC COM NO NC COM NO NC COM NO NC COM NO
NC COM
NC COM NO NC COM NO NC COM NO NC COM NO
ALARMNC COM