Configuring Linksys Wireless Ethernet Bridge

Prof. Yousif

@

Valencia Community College

Wireless Ethernet Bridge

• Home Page• Default Address

192.168.1.225

Enable LAC#5

The default SSID is “linksys” unless a beacon is heard with a different SSID

Basic Configuration

admin

Change to WB#, where “#” refers to your PC number

Default PW is: admin

Basic Configuration

Auto sensed from the beacons broadcasted by the Cisco AP

Basic Configuration

Must enter GW Address

No Security Config. “Later”

Confirm!

Web Access: Open your browser and type the address you used during configuration: 10.0.0.3

Make sure that you Ethernet Card is configured to be on the same network

Confirm Association

IP Add. Of PC MAC Add. Of W. Bridge

Check the Firmware Version

Old

Upgrade the WB Firmware

Download the firmware

Capture

Install firmware Upgrade

Make Sure that you enter the correct IP address of the WB and the correct password

Site Survey

Supports WEP Only,Doesn’t Support WPA