NoahLink, Noah™ 4, and HIMSA are trademarks or registered trademarks of Hearing Instrument Manufacturers Software Association (HIMSA A/S). Bluetooth® is trademark or registered trademark of Bluetooth® SIG. Pentium® and Intel® are trademarks or registered trademarks of Intel® Corporation. VGA® and IBM® are trademarks or registered trademarks of IBM® Corporation. USB® is trademark or registered trademark of USB® Implementers Forum, Inc. Windows® XP, Windows® Vista, Windows® 7, Windows® 8, Windows Media® Player and Microsoft® Internet Explorer are trademarks or registered trademarks of Microsoft® Corporation. PDF™ and Adobe® are trademarks or registered trademarks of Adobe® Systems Inc. Connexx™, Unity™ and SiFit™ are trademarks of Siemens Audiologische Technik GmbH. Other brands or labels possibly mentioned here are trademarks or registered trademarks of their owners.

Note: Windows® XP SP3, Windows® Vista, and Windows® 8 are also supported.

Siemens Hearing Instruments, Inc.10 Constitution Avenue Piscataway, NJ 08854 Technical Support: (888) 231-1333 www.usa.siemens.com/hearing

Information in the manual subject to change without notice. This is commercial computer software documentation owned by Siemens Hearing Instruments, Inc. (“Siemens”). All license rights are governed by Siemens standard commercial license between Siemens and the Licensee. Copyright © 2013 Siemens Hearing Instruments, Inc. All rights reserved.

© 2013 Siemens Audiologische Technik GmbH. Subject to change without prior notice. Report-/Druckmodul List & Label® Version 8.0: Copyright combit® GmbH 1991-2001

Recommended system requirements

Processor (CPU) 2.8 GHz (single-core), 1.8 GHz (dual-core) Hard-disk space 2.0 GB RAM 2.0 GB Graphics display Resolution 1280 x 1024 Programming interface NOAHlink™ Optical Drives DVD Operating system Windows® 7

Part #10537010 10/13 1.0 22C714 2K SHI/14453-13

Siemens Hearing Instruments Inc. 320 Pinebush Road Cambridge, ON N1T 1Z6 Tel: (800) 663-0620 Fax: (888) 429-4644 www.siemens.ca/hearing

Life sounds brilliant.

CONNEXX® 6.5.5Fitting Software including SIFIT™ 6.10.3

Report-/Druckmodul List & Label®Version 8.0: Copyright combit® GmbH 1991-2001

November 2013

Stand-alone or NOAH 4 installation.

1. Insert the CONNEXX DVD in the DVD drive.

2. Browse to the DVD drive, and run “setup.exe”.

3. The CONNEXX installation program will load. Continue to follow the instructions of the installation wizard. The installation program copies all program files, a device driver, and SIFIT, if necessary, from the DVD to the hard disk. This may take several minutes. There will be two “Finish” screens. Click “Finish” on both.

4. Close all programs and exit Windows. Reboot the computer.

Note: NOAH 4 will add the Siemens logo automatically to its list of available modules

The CONNEXX 6.5.5 shotcut will be located at Start > All Programs > Unity.

Installation Instructions under NOAH 4

IMPORTANT: You must install CONNEXX and SIFIT!

NOTE: NOAH 4 needs to be closed before installing