5
Thank you for purchasing our company’s DIY makeup mirror
fi l l l ight products, this product supports DIY own home
mirror, instantly make their own mirror into a modern
fashion makeup with LED Fill mirror.
Product Features:1.The standard USB power supply, safety gener ic.
2.PC soft mask, don' t stab the eye
3.Concealable wir ing, s imple and neat
4.Al l t ransparent l ines, beaut i fu l and sty l ish
5.Luminance color temperature adjustable
Product parameters:Product Name: Vani ty Mirror Lights
Bulb s ize: 45 MM
Power supply: Standard USB 5V 2A or above
LED color temperature: 3200K&6500K
Lamp power: a s ingle lamp maximum 2W
Mater ia l : ABS+ PC
Wisdom in design: I t is easy and convenient to use
st icker for mirror glass, wood, plast ic and metal surface.
According to their own unique design DIY instal led in the
dresser f i l l l ight and decorat ion.
Rest assured dressing: USB low vol tage power
supply, safe! 5- level luminance adjustable , sui table for
d i fferent dressing needs.
EN
Functional descriptionShort press:Luminance +Long press:Warm light regulation
Power on/offShort press:Luminance -
Long press:Cold light regulation
DC5V USB output port
Press and hold the endless color temperature to release it at the appropriate position to maintain the current color temperature.
Precautions for use1.I t is recommended to choose 2A or above USB power
adapter, mobi le phone charger and other standard USB
mobi le power can be used.
2.The product uses doublesided adhesive paste f ixed,
requir ing instal lat ion of the bonding surface must be
clean, dry, smooth, can not have rust and oi l .
3.The wire can be adjusted through the winding between
the base slot , and the bulb spacing can be adjusted
EN
between 10-26cm.
When the bulb is pasted ,you must press the product for
about 30 seconds , i t takes 24 hours to achieve the best
adhesive strength
Rotating telescopic cable
Clockwise by rotating the middle frame
Half-turn the middle frame counterclockwise
Adjusting the length of the contraction wire
gently pull the two wires can be pulled out of wire
Note :Must twist the bulb in the opposi te direct ion to pul l
out the wire .
Hide on the border of
the mirror
Special feature
Disassemble the base and route the
wires f rom the same side, hiding the
s i res to the mirror f rame or the back
of the mirror.
The USB prot on the s ide of the
control switch can charge the cel l
phone or other electr ical appl iances.
EN
Installation steps1. Cosmetic mirror or be instal led Surface treatment:
should be st icky surface should be dry, c lean, no rust ,
oxidat ion, grease,dust and other pol lutants.
2. According to the design of the number of mirrors and
bulbs each bulb instal lat ion locat ion, note the lamp
spacing of up to 26cm, the minimum spacing of about
10cm.
3. Remove the product to determine the power and
control switch to place the seat is appropr iate to
determine the f i rst l ight paste locat ion (wi th the control
switch to connect the f i rst l ine)
4. The bottom of the product double-sided adhesive tape
tear off the f i lm, and then aff ixed to the f i rst lamp
posi t ion, forced down,so that double-sided adhesive
paste better,Make the tape and the bonding surface get
fu l l contact .
EN
