FREEFREE

ROCKET PATTERNROCKET PATTERN PDF PRINTABLECRICUT DESIGN

LINK

Materials &Materials &

suppliessupplies

3 Sheets of red1 Sheet of yellow

1 Sheet of light blue 1 Sheet of light gray

Red

9x12 FELT SHEETS

EMBROIDERY THREAD WhiteDark Gray Light Blue Yellow

Buttons ✨ Fiber-fill ✨Needles

Scissors ✨Pins

CRICUT DESIGN SPACE LINK

https://design.cricut.com/landing/proj

ect-detail/5face1ac13f28d04a4cf8f97

InstructionsInstructions

2. Pin each pattern piece to your felt and cut around them.Another way to do this is use a clear glue stick and lightly gluethe paper on the felt. It will dry clear and it peels right off ☺)

Print out the two white pattern sheets in this post. If youdont have a printer you them out yourself

1.

If you are using the cricut designspace link, skip the next 2 steps

4 Straight stitch around the yellowand gray eye pieces

3. Straight stitch around the grayStraight stitch three horizontallines across

Use two strands of embroidery thread every time you sew.Match the color thread with the felt your using

PAGE 1

InstructionsInstructions

5. Straight stitch around all the redpieces like pictured. Trim the extrared that hangs over on the strips.

6. Blanket stitch aroundthe red pieces like

pictured. Leave gapswhere ther yellow lines

are to stuff. Leave theantenna open but close

the jetpacks

7. Straight stitch the gray ovalshapes on the jetpacks. It’s alittle tricky since they arealready stuffed. This step couldbe left out or even glues on

8. Attach the antenna in the middle of the piece that you madein step 5. I like to use a button underneath, but you dont havetoo. It’s a little tricky but i just sew from the underside until the

antenna is securely sticking straight up

PAGE2

InstructionsInstructions

9. Place the piece from the laststep onto the top red piece withthe eyes. Blanket sttch around it(or backstitch) leaving a gap forstuffing. This will be done after thenext step

10. Blanket stitch the top and bottomred pieces together, leaving a gap forfilling. Blanket stitch it shut afterward.

11. This parts a little wierd so bare with me. Youwill be now filling the top part. When its full youhave to pin down the gap and back stitch it shut.It’s a little tricky!

12. The final step is sewing thejetpacks On. I like to use buttons, igot through them and just sew themon to the edge of the rocket piece.You could skip the buttons and justsew the underside to it.

PAGE3