“Big Bud the Tug”Need to haul a load of ‘Premium Quality Junk’ to another land?
“Big Bud” can do the job.
www.build-it-yourself.com
Tug Boat Engine Room
www.build-it-yourself.com
Mount the Power Top Gear Train and an RCX on two 15 hole beams.
Tug Boat CabinThe walls will be 2.5” tall. Measure and mark with a pencil three 2.5” cardboard strips.
www.build-it-yourself.com
2.5”
8.5”
2.5”
Tug Boat CabinMeasure 5.5” on two strips.You Know what to do on the third strip.
www.build-it-yourself.com
5.5”
2.0”
2.0”
2.5”
Tug Boat CabinCut out the two 5.5” x 2.5” strips. These will be the two cabin sides.Cut out the 6.5” strip. This will be the front of the main cabin.
www.build-it-yourself.com
5.5”
2.5”
Tug Boat CabinDecorate the sides and front. Use blue, red and yellow pencils to shade the wood panels. Then outline the wood panels with a black pen.
www.build-it-yourself.com
Cut out windows and doors. Then paste them on.
Left side Right sideFront
Tug Boat CabinWhen all sides are decorated, then you can tape them together.
www.build-it-yourself.com
Tug Boat Cabin
www.build-it-yourself.com
Wrap the sides around the engine room.
Glue Popsicle sticks on top to make the structure strong.
You can tape the sides to the base
It’s best not to put a back wall on so you can easily get to the RCX on/off buttons.
Tug Boat Cabin
www.build-it-yourself.com
Cut a cabin roof. Then punch a hole through the roof with a pencil so the gear train shaft sticks out.
Captain’s Cabin
www.build-it-yourself.com
Cut out a 3” diameter circle or use 3” circular container lid. Build the captain’s steering wheel and glue it to the circle.
Captain’s Cabin
www.build-it-yourself.com
Cut out a 1.5” x 6” strip of cardboard and draw wood panels on it like you did for the main cabin. Then tape coffee stirrer sticks on the back.
Front Back
6”
1.5”
Captain’s Cabin
www.build-it-yourself.com
Bend the sides carefully until they fit around the circle. You can tape the sides to the circle on the outside and the inside.
Tug Boat Sides
www.build-it-yourself.com
Cut and sculpt a 1” x 1” strip of foam rubber for the sides of the tug.