Next attach the lower webbing strap on both sides and tension (1). Peg the rear pegging points (2) (on both sides) and then the two front corners (3) ensuring that the vestibule is ‘square’ on the tent. Do not pull forward too much as it may pull the vestibule off the roof of the tent — tension vestibule using the webbing straps to pull it back onto the tent.

Peg the remaining pegging points. Ensure the vestibule is tensioned across the front and sides and re-peg if necessary.

1

3 2

Go inside the vestibule and peg the front corner guy lines of the tent into the corners of the vesti-bule

Croyde 6 Vestibule Instructions

Thank you for purchasing your Kampa tent accessory. Please read these in-structions carefully before attempting to set up your vestibule and retain for fu-ture reference. If used properly, your vestibule should give you years of trouble free use. We recommend that your tent and accessories are insured against accidental and storm damage as this is not covered by the warranty. Tents con-tain a high proportion of synthetic materials and under certain conditions will be affected by condensation inside the tent. This should not be confused with leak-ing and condensation can be improved by ensuring adequate ventilation.

We recommend a trial run before using your tent and accessories for the first time. This will allow you to familiarise yourself with the tent, its set up and any limitations the tent may have for your particular use.

A Kampa Genuine Accessory

PREPARATION Set your Kampa tent up in your desired location allowing enough space for the vestibule extension. SET UP To protect your vestibule from dirt and damage, it may be beneficial to lay a groundsheet down before unpacking. Unpack the vestibule and lay out in front of the tent canopy. Indentify the different parts of the vestibule, the window and door are at the front and the webbing straps are attached to the rear of the Vesti-bule, the part that attaches to the tent. Ensure that the front door is fully closed. Un-peg the front guy lines on the tent. With help, throw the rear of the vestibule over the front pole sleeve of the Croyde 6 canopy.

At this stage it will help to secure the vestibule to the tent by attaching the upper-most strap on both side to the tent frame.

Go inside the tent and attach the velcro fastenings around the front canopy poles of the tent—both sides.

Securely peg the pegging point indicated on the following picture. This should be in line with the front canopy pole of the tent. Repeat the other side.

Attach fastenings around tent canopy pole