Date post: | 08-Aug-2015 |
Category: |
Business |
Upload: | indiamart-intermesh-limited |
View: | 326 times |
Download: | 2 times |
Daftech 1
Dissolved Air Flotation
Your Logo Here
Shaju Peter
Managing Director
Daftech Engineers Pvt. Ltd.
Shaju Peter
Managing Director
Daftech Engineers Pvt. Ltd.
Daftech 2
What Is It?
A liquid solid separation process achieved by microscopic air bubbles attaching themselves to solids suspended in a liquid and causing these solids to float to the surface.
Daftech 3
Why Should You Use It?
Smaller space requirement
Example: 1 MGD – 18’ dia DAF clarifier
DAF recovered solids are 3 to 4 times thicker than gravity sedimentation
Faster processing times – 3 minutes compared to 2 to 3 hours in conventional clarifiers
Daftech 4
How Does It Work?A stream of treated water (recycle) is taken from the DAF unit and is pumped into an Air Mixing Tube. Air and water are then ULTRA MIXED under pressure in the Tube and then is released at a point that allows it to mix thoroughly with the raw waste stream entering the cell.
Daftech 5
As the air comes out of solution millions of bubbles are attached to the material that is going to be floated to the surface, causing the solids to agglomerate and rise to the surface of the tank in the form of a sludge blanket on top of the clear water.
This sludge blanket is then allowed to thicken and de-water prior to removal by a rotating scoop.
Daftech 6
How Efficient Is the DAF System?90 to 98 % capture of TSS with chemical addition (typically a polymer)
2 to 3.5 % sludge consistency
85 to 90 % air dissolution capability
80 to 90 % oil and grease removal
50 to 80 % BOD reductions
Daftech 7
Where Can You Use the DAF Unit?
Industry Anticipated Performance
Pulp and Paper
Fibre recovery 90 to 98 % recovery
Daftech 8
Where Can You Use the DAF Unit?Food Processing
CanningPrepared foodsSnack foodsSeafood
85 to 95 % TSS Removal85 to 95 % O&G Removal
Daftech 9
Where Can You Use the DAF Unit?Oily WastesOil refineries
Car wash operations
Paint shops
85 to 95 % TSS Removal90 to 95% O&G Removal
Daftech 10
Where Can You Use the DAF Unit?Food ProvidersChicken ProcessingCattle slaughteringMilk and Dairy
85 to 97 % TSS Removal95 to 99 % O&G Removal80 to 85 % BOD Removal
Daftech 11
Where Can You Use the DAF Unit?MiscellaneousTanneriesAlgae removalPharmaceuticalTextile effluentsSewage treatment
90 to 95 % TSS Removal
Daftech 12
Recycle and Partial Pressurization
Raw influent is introduced directly into the flotation cell. A portion (generally 25% of raw flow) of the system effluent is pressurized and recycled to the flotation cell where it is blended with the raw wastewater flow.
Daftech 13
Air Mixing System
The pressurization system uses compressed air that is forced into solution by a controlled air-water interface and mixing components located inside an Air Mixing Tube. The Tube is fitted with an automatic air bleed off valve and pressure safety relief valve.
Daftech 14
Sludge Removal System
The flotation cell is fitted with a spiral scoop mechanism to assure effective removal of the floating material. The surface skimmer,centre distribution tube, and lower sludge scraper arm are all driven by a stepless variable motor
Daftech 15
Sizing Criteria
Hydraulic loading (m3/hr./M2)
Solids loading (kg./M2/hr.)
Air-to-solids ratio (kg. of air/kg. of solids)
Daftech 16
Hydraulic Loading
The relationship of the surface area of the flotation cell(m2) versus the influent rate into the flotation cell (m3/hr.) For full pressurization systems, the influent rate is the capacity of the pressure pumps. For recycle pressurization systems, the total influent is the raw influent flow plus the recycle pump rate. It is possible to obtain up to 9.6m3/hr/m2 depending on the application.
Daftech 17
Solids Load
The relationship of the surface area of the flotation cell (M2) versus the amount of solids entering the system per hour. Design points for solid loadings range from 10 to 16 kg./M2/hr. Depending upon the application and the type of solids involved.
Daftech 18
Air-to-Solid Ratio
The ratio of the number of kg of air to the number of kg. Of solids. Generally, air is injected in a range of 2 to 8 % by volume of raw wastewater intake. Depending upon the type of solids and application, the air-to-solids ratio ranges from 0.02 to 0.1.
Daftech 19
Case History Adnip Tissue, Abu Dhabi
DAF clarifier installed in the white water stream to recover fibre and clarified water at 26 m3/hr. The clarified water containing TSS less than 30 ppm is fully recycled in the production process thereby reducing fresh water intake. The equipment cost was recovered in 9 months of operation by way of recovery of fibre and water.
Daftech 20
Chitale Dairy, Sangli
The unit treats 45m3/hr of dairy wastewater in the primary mode.
Pollutant Inlet Outlet
TSSBOD
900 ppm1500 ppm
50 ppm600 ppm
Daftech 21
Kaleesuwari RefineryChennai
The DAF unit of just 4 feet diameter treats 100m3/day of effluents.
Pollutant Inlet Outlet
TSS 1000 ppm 50 ppm
O&G 800 ppm 15 ppm
BOD 400 ppm 200 ppm
Daftech 22
SPIC Pharma, Cuddalore
The DAF unit treats effluent containing very high TSS of 8000 ppm from Penicillin production. The flow of 10m3/hr has O&G of over 6000 ppm. The outlet TSS of 100 ppm and O&G of 50-100 ppm is achieved by a very high rate of recycle – as high as 200%.
Daftech 23
Hydromagx, Jeddah
The DAF unit treats composite wastewater originating from slaughterhouse and dairy operations.
Pollutant Inlet Reduction
TSS 950 ppm 95%
COD 1800 ppm 75 to 80%
Daftech 24
Gadre Marine ExportRatnagiri
The DAF unit handles 40 m3/hr of their wastewater stream containing 3500 ppm of fine particles of fish meat which they were otherwise wasting. The system recovers the suspensions which are used as input for another food product. The unit is fabricated in SS 316.
Daftech 25
Developments
Retention time progressively reduced from 20 minutes to 3 minutes.
In circular DAF units overflow weir internalized to reduce space.
Large saturation vessels replaced by air mixing tube of just 10 seconds retention.
Trials are in progress with DAF pump to eliminate compressed air usage.