Data Analysis of Mo (13)
System II
Mo (13)
--- Gap Measurement
E sat = 340.94 ± 72.52 MV/m
Mo (13)
50 150
--- Gap Measurement
E sat = 321.61± 69.41 MV/m
--- Gap Measurement
50 125
E sat = 306.61± 68.63 MV/m
Mo (13)
Mo (13)
--- Gap Measurement
E sat = 265.70 ± 66.09 MV/m
Mo (13)
--- Gap Measurement
E sat = 315.40 ± 71.63 MV/m
Mo (13)
Spot Esat [MV/m] Stdevz30 340.94 72.52z28 321.61 69.41z26 306.61 68.63z24 265.70 66.09z22 315.40 71.63
Ê sat = 308.53 ± 31.10 MV/m
Status System I and II
Status System I and II
System I System II
Done
Change electronics
Mo (13)
22 Spots-27.5 nF
-60nF
Re-code Labview
Sent to SEM
Currently
Check Labview
and componen
ts
Cu (14) 3 Spots -60nF
Near Future
Measure Gap with equation
Implement High T sample holder
Non-Contact Positioning Device
Philtec
Non-Contact Positioning Device
• D-type sensor has to be used (near side)• Perpendicularity: they can calibrate it to any
perpendicularity• Price: 5173€ (sensors+drivers) + 2310€ (passthru
flange)• Using ceramic jacket:– Angle always the same
• Calibrate to ceramic independently of the material• Go for it?