CAD-CUT Materials® TEK Products™
Base Layer Garments
MAINTAINING GARMENT FEATURES
Myogrid Performance Apparel features technological advances which set it apart from most other garment types.Special care must be taken to maintain garment features and achieve optimal results when decorating this apparel.
Stahls’ heat transfer materials have been tested for adhesion to Myogrid apparel.We recommend the following materials for application:
These materials have been wash-tested to 25 washes.
Sample Garment Decorations
Decorated with SuperTEK Opaque
Decorated with SuperTEK Gloss Clear
MYOGRID PERFORMANCE APPAREL®DECORATING INSTRUCTIONS FOR www.Stahls.ca | 800.521.5255
™
®
SportFilm Lite
Premium Plus
Fashion-LITE
Fashion-FILM Electric
Gorilla Grip II
Super Film
3M Scotchlite 5807
Reflective
Fashion-REFLECT
®
™
™
™
®
™
™ ™
™
SuperTEK Opaque
SuperTEK Sublistop
SuperTEK Gloss Clear
SuperTEK Matte Clear
FoilTEK Metallic Gold
FoilTEK Metallic Silver
FoilTEK Metallic White
FoilTEK Silver Shift
FoilTEK Gold Shift
™
™
™
™
™
™
™
™
™
Training Garments
Transfer Size
We recommend that you avoid decorating areasthat have the following properties:
� High-compression areas� Areas that will be over-stretched� Areas that require high breathability
NOTE:� The abdominal and side areas of some base layer garments contain medium and high compression. We do not recommend placing transfers in these ares.
� The ribbed texture on select garments will prevent transfers from adhering completely to the garment.
� The sides and underarms are areas that experience higher stretch and have venting to increase breathability. These areas are not recommended for decoration.
� The flat smooth areas of the chest and sleeves are the best locations for decoration.
Enhanced ventilation areas containingMYO-VENT technology (i.e. areas in the lowerchest, sides, center back, etc...) are notrecommended for decoration
™
The size of the transfer is important. Placing large transfers on areas that are likely to be over-stretched during wear (such as the bust area and sides) is not recommended.
Placing a large transfer over an area of higher compression or breathability (vented areas)can decrease the performance value of the garment and is not recommended.