Date post: | 31-Mar-2015 |
Category: |
Documents |
Upload: | korey-jaggers |
View: | 213 times |
Download: | 0 times |
Dennis Fire Appliances
Operations & use
PTO
Step 1
Move slide cover towards the drivers seat to lock out the
gearbox
Step 2
Select drive on the gear selector to
engage the pump drive
Step 3
Move the leaver back to engage the pump bay throttle control
Step 4
The warning light should now show
To disengage the PTO reverse the order
Water pump
Pump drain tapsFor winter draining to prevent
pump frost damage
Supply valve for High Pressure
hose reels
Shut off valve for NearsideHigh Pressure hose reel.Select ‘Foam’ or ‘Water’
(to be closed when not in use)
Main water tank to pump Shut off valve
Engine speed control.
Shut off valve for OffsideHigh Pressure hose reel.Select ‘Foam’ or ‘Water’
(to be closed when not in use)
Suction fill coupling
Please note filters must be used on open water.
Hydrant fill to water tank
Low pressure deliveries
Low pressure water
Open main water tank to pump Shut off valve
Open Low pressure
delivery valve as required
High pressure water
Open supply valve for High Pressure hose
reels
Shut off valve for Nearside
High Pressure hose reel.
Select ‘Foam’ or ‘Water’
Shut off valve for Offside
High Pressure hose reel.
Select‘Foam’ or ‘Water’
Open main water tank to pump Shut off
valve
Generator
Step 1
Move slide cover towards the drivers
seat
Step 2
Move the leaver back to engage the pump bay throttle control
Step 3
The warning light should now show
Step 4
Turn on the generator switch
Light mastThese controls are found in the passengers side front locker
DO NOT move the vehicle with the mast raised
Rotate the valve to ‘Raise’Press & hold the raise button until the light mast
is fully raised.Rotate the valve to ‘Lower’ to stow the mast
Raise the engine speed in the pump bay to maintain voltage
output