Rev. 1.0 – 23.05.2019

Quick-Start Guide:

Using your Cardo® Device with BRP

Connect™

Rev. 1.0 – 23.05.2019

1st. Step: Make sure your Cardo® Device is running the latest available firmware (https://www.cardosystems.com/support/).

2nd. Step: Make sure your Phone’s Operating System, Cardo® Connect app and BRP Connect™ app are installed updated to the latest versions.

3rd. Step: Connect your Cardo® Device via Bluetooth to your Phone (further instructions available in the respective manuals, if required).

4th. Step: Confirm if your Cardo®

Connect App is recognizing the Headset by launching it on the phone after the 3rd. step (if connection is not possible, restart your phone and go back to the 3rd. Step).

Rev. 1.0 – 23.05.2019

5th. Step: Open the Bluetooth Settings of your BRP® Vehicle and connect your Phone and Cardo® Device as a Rider Helmet. (further instructions available in the respective manuals, if required).

6th. Step: Open your Phone’s Bluetooth Page and confirm that both BRP Connect™ and Cardo® Device are connected.

Final Step: Connect your Phone to your BRP® Vehicle via the USB Cable and launch BRP Connect™ (further

instructions available in the respective manual, if required).

Your Cardo® Device should now be fully useable during your ride!