COMMON-RAIL – UNIT-INJECTOR - HEUI
DIESEL TECHNOLOGY SPECIALIST SERVICE:
95045 MISTERBIANCO (CT) ITALY – Via Salvatore Averna, 3Tel. +39 095 481463 PBX – Fax +39 095 476164 – Info-Tech: Tel. +39 095 481855 PBX
www.coronadiesel.it – E-mail: [email protected]
◊ Testing any type of injector either magnetic or Piezo;◊ Injectors Coding (also coding ISA on Piezo Bosch);◊ Automatic or manual test;◊ Injector angle curve visualization;◊ Self learning on new injectors;◊ Printed reports;◊ Chiller supplied;◊ Maximum pressure 2500 BAR
ELECTRICAL CONTROL
- Coil Inductor- Capacitor (only on Piezo injectors)- Coil Resistor- Insulation- Current max
MECHANICAL-HYDRAULIC CONTROL
- Static seal (LEAKAGE)- Delivery at max engine (MAX DELIV.)- Delivery at idle engine (MIN DELIV.)- Pre-Injection delivery (IMA DELIV.)- Starting value (START INJ)- Start injection dynamic response
(START IMA)- Injector coding
PRINTING REPORT
COOLER
P.N.: CD-RD17
ARTICLES INCLUDED:
STANDARD EQUIPMENT
(Includes all current types of injector cables and back-flow attacks)
ARTICLES ON REQUEST:
AVAILABLE IN CATALOG ALL TYPES OF ADAPTERS FOR COMMON-RAIL
TRUCK INJECTORS
ELECTRICAL CONTROL
- Coil Inductor- Capacitor (only on Piezo injectors)- Coil Resistor- Insulation- Current max
MECHANICAL-HYDRAULIC CONTROL
- Static seal (LEAKAGE)- Delivery at max engine (MAX DELIV.)- Delivery at idle engine (MIN DELIV.)- Pre-Injection delivery (IMA DELIV.)- Starting value (START INJ)- Start injection dynamic response (START IMA)- Injector coding
SCREEN REPORT
PRINTING REPORT
Factory default value comparison reports with individual injector coding
InjectorEUP
InjectorDelphi 1.1
InjectorCR
InjectorDelphi 1.5
InjectorDenso
InjectorL’Orange
InjectorCR Truck
InjectorBoschPiezo
Injector DensoPiezo
Injector Siemens
Piezo
COMMON-RAIL INJECTORS SOFTWARE APPLIED TO ■ 555-DDP/R ■ 555-DDP/4-R ■ 555-8G / N ■ 555- @√ √ √ √
PLOT CARATTERISTIC
The test draws five curves at five differentpressures; delivery is measured continuouslyby varying injection time from a max of 1200us up to a minimum of 0 us through 0,020 ussteps.The curve drawn (1) is normally between themin (2) and the max (3) curve. The column onthe left shows details about minimum, nominaland maximum delivery, as well as injectiontime current absorbtion and test result.
Note : The points indicated are approximate.
InjectorXPI
InjectorHPI
InjectorHDP
InjectorCaterpillar
InjectorDenso
Komatsu
InjectorMTU
InjectorDenso John
Deere
InjectorECR
1
2
3
Start
MaxLoad
IntermediateLoad
Pre-Injection2
Pre-Injection1
PRINTING REPORT
COMMON-RAIL INJECTORS SOFTWARE APPLIED TO ■ 555-DDP/R ■ 555-DDP/4-R ■ 555-8G / N ■ 555- @√ √ √ √