Date post: | 02-Nov-2015 |
Category: |
Documents |
Upload: | jmac-supply |
View: | 29 times |
Download: | 0 times |
DTK-MB Series with Snap Track ChannelQuick-Install Mounting System for DTK-2MHLP and DTK-2MHTP
One DITEK Center1720 Starkey RoadLargo, FL 33771
1-800-753-2345 Direct: 727-812-5000Technical Support: 1-888-472-6100
www.ditekcorp.com
Doc. Number: SPS-100041-001 Rev 3 01/122011 DITEK Corp.
Specification Subject to Change
The DTK-MB Series, with Snap-Track, is the mounting base system for DTK-2MHLP surge modules. This mounting system allows the installer to protect multiple circuits terminating at the same point . Perfect for alarm panels, fire control systems, or other low voltage communications circuits. The DTK-MB makes for a quick and easy wire management solution.
FeaturesAvailable in arrays of 1, 2, 3, 4 or 5Straight-in/straight-out terminal connectionsSingle point ground for ease of installationFast installation saves timeBenefitsScalable up to 10 pairs of protectionProtect multiple line voltages in one cabinetUp to 10 data, telco or other communication pairs
protected with only one ground connection and only one backplane mount, simplifying installation.
Ordering GuideSingle unit: DTK-MB10 With surge module:
DTK-2MHLPxxBWB (WB = With Base = DTK-MB10)Horizontal wiring across base: DTK-MBVMultiple bases: DTK-#MB - # indicates the array number of
modular bases desired (2-5)
DimensionsDTK- MBV (2 pairs): 3.25H x 1.50W (82.5mm x 38.1mm)DTK- MB10 (2 pairs): 3.25H x 1.50W (82.5mm x 38.1mm)DTK- 2MB (4 pairs): 3.25H x 3.00W (82.5mm x 76.2mm)DTK- 3MB (6 pairs): 3.25H x 4.50W (82.5mm x 114.3mm)DTK- 4MB (8 pairs): 3.25H x 6.00W (82.5mm x 152.4mm)DTK- 5MB (10 pairs): 3.25H x 7.50W (82.5mm x 190.5mm)
DTK-5MB
DTK-4MB
DTK-3MB
DTK-2MB
DTK-MB10
DTK-MBV
Slide Number 1