Date post: | 22-Jul-2015 |
Category: |
Documents |
Upload: | anpingyadong |
View: | 388 times |
Download: | 3 times |
Materials
Galvanised Wire Mesh0.5mm wireWire Cutters/Jewellery Wire Cutters (for a closer cut)Flat Pliers (If you’re using regular cutters)White Spray PaintTape Measure
First Step
First off, you will need to have a specific height and width in your mind, deciding the dimension, you need to go to the next to step.
Second Step
2.Now, in this step you need to cut according the wire mesh as your decided height and weight.
Third Step
3.After you have cut along the whole length, you should afterwards, snip off the wire by the help of jewelry pliers. The other option is to bend them back onto themselves which can be done with the help of flat nose pliers.
Seventh Step
7.For the base you will have to re-measure the dimensions of the box, and then cut wire mesh from the role for the base according to the dimensions.
Eighth Step
8.With the help of a meter, you can measure the length of finer wire and after doing that, you should wrap the two ends of the box.
Ninth Step
.Now comes, the time when you have to attach the base that you cut from the wire mesh roll in the 7th step.