Date post: | 14-Dec-2015 |
Category: |
Documents |
Upload: | arjun-hodkinson |
View: | 213 times |
Download: | 0 times |
The Effects of Extreme Temperatures on the
Lifespan of Battery ChargeDonn Arnold- Krum ISDLaura de Lemos- Carrollton Farmers Branch ISD
RET Project- Summer 2009 College of Engineering, Dept of Electrical
Engineering University of North Texas
NSF Grants: NSF IIS-0844342, DLR, 0431818, CI-TEAM 0636421, CRI 0709285
August 13, 2009
Will insulation of the sensor boxes help to sustain the lifespan of battery charge by
maintaining battery temperatures within their optimal (manufacturer’s recommended)
operating temperature ranges?
Thermal Effects on Lifespan of Battery Charge When
Deployed in aWireless Sensor Network
•Initial concern: extreme thermal effects on the wireless sensor and the lifespan of the battery’s charge •After research, our primary concern became the thermal effects on the batteries themselves
•We decided to study the effects on the lifespan of the battery’s charge when insulation is installed in wireless sensor boxes
Introduction
Hypothesis: By controlling the internal temperature of the boxes within manufacturer’s prescribed operating temperature range, the lifespan of the battery’s charge will be extended.
During the testing of the effects of insulation, 3 types of batteries were tested: alkaline, nickel metal hydride, and lithium ion batteries.
Introduction
•Limiting factor for motes is generally the battery [1]
•Battery must be kept within a limited operating temperature (manufacture recommended) range so that a battery charge’s lifespan can be extended[2]
Research- Battery
• At the lower extreme, the electrolyte will freeze [3]• At the upper extreme, active chemicals may break down destroying the battery [3] • In between these limits, cell performance generally improves with temperature (with an upper limit)[3]
•Optimum performance: -20 to 54°C [4]•Manufacturer recommended operating temperature:
-18 to 55° C [5]
•For most cells, up to 75% of rated capacity at room temperature can be delivered at O° C [4]
Research- Alkaline Battery
•Battery performance still impacted by temperature within the recommended range [5]•Due to how fast critical fuels, water and hydroxyl ions can move and react [5]•Lower temperature limit is in part due to where the electrolyte freezes [5]•Current flow stops at the freezing point
•High drain rates in cold environments [5]
Research- Alkaline Battery
•Optimum performance: 0 to 45° C [6]•At -20° C, the battery ceases to function [7]
•For optimum battery life and maximum life cycle, the battery should be operated at or near room temperature (20° C) [6]
•Capacity of the battery decreases as current increases, especially at lower temperatures [6]•Very poor low temperature discharge performance [8]
Research- NiMH Battery
•Higher temperature yields higher self discharge rate [9]•Cycle Life and Temperature•30° C, cycle life reduced by 20%•40° C, cycle life reduced by 40%•45° C, cycle life reduced by 50% [7]
•Operation at high temperatures can:•Cause cell to vent, releasing gas and possibly electrolyte through the safety vent•Hasten the deterioration of the separator and other materials in the cell [6]
Research- NiMH Battery
Also known as the lithium iron disulfide battery (LiFeS2) •Optimum temperature range: 20 to 40° C [10]•At -20° C, the battery ceases to function [7]
•Lowering the discharge temperature causes a reduction of capacity and an increase in slope of discharge curve [10]•Rate of voltage decrease is more rapid at colder temperatures [10]
Research- Lithium Ion Battery
•At higher temperatures, chemical deterioration may be rapid enough during discharge to cause a loss of capacity [10]•Higher discharge rates with elevated temperatures can cause self-heating [11]•Contains safety features:• thermal switch- limits current when temperature reaches 85 to 95˚C•pressure release valve- activated by excessive internal pressure [12]
Research- Lithium Ion Battery
Related Work•Arizona State University-recommended thermal insulation [13]•NASA Mars rovers- efforts to maximize thermal resistance [14]•Worcester Polytechnic Institute- lithium ion batteries subjected to high temperatures can explode [15]•Chulsung Park at the University of California at Irvine & NEC Laboratories of America- effects of high and low temperatures on batteries [16]•UNT Electrical Engineering Department- motes need to be able to survive in extreme environmental conditions [17]
High and low temperature extremes cause batteries to self-discharge. This reduces the current available for wireless sensor operation.
To reduce these effects, we will implement a pattern of insulation of the wireless sensor boxes thus: •1 box- uninsulated (control)•1 box- polystyrene rigid foam board (pink)•1 box- foil-faced polystyrene rigid foam board (white)
Boxes will be subjected to high summer temperature extremes.
Problem Definition
Throughout all the experiments, each sensor box contained the following:•Crossbow Mote: IRIS XM 2110 2.4 GHz
(micro computer board)•Two AA Battery Pack•MDA 300 Acquisition Board
Experimental Design
Throughout all the experiments, 4 types of sensor boxes were implemented.
Experimental Design
1st Deployment•30 motes in 30 sensor boxes spaced about 10 m apart•All were powered by alkaline batteries•2 boxes contained pink insulation •2 boxes contained white insulation•2 remaining boxes contained no insulation •Note: the second set of three boxes allow for an experimental redundancy•Data collected July 25 to July 27 •1 reading every 6 minutes
Experimental Design- Discovery Park
Experimental Design- DP
15 14 13 12 11 10 9* 8 7* 6 5 4 3* 2 1
30 29 28 27 26 25 24 23 22 21 20 19 18 17 16*
non-transparent lid, uninsulated
non-transparent lid, pink insulation
1st Deployment- All alkaline batteries
transparent lid, uninsulated
non-transparent lid, white insulation
Our focus in this deployment were boxes #2, 8, 10, and 15.
*This indicates an experimental redundancy.
Results- DP
Time (sec)
Time (sec)
1st Deployment•Weather conditions were cloudy and overcast greatly reducing the effect of the radiant barrier •Very similar results with pink and white insulation
Results- DP
Time (sec)
Time (sec)
1st Deployment
•Unusual results for the transparent lid, uninsulated box
Results- DP
Time (sec)
Time (sec)
1st Deployment
•#8 retained 0.1 v less than both of the insulated boxes
2nd Deployment•21 motes in 21 sensor boxes spaced about 5 m apart •3 rows of 7 each
•Data collected from August 5 to August 10•1 reading every 5 minutes
Experimental Design- Discovery Park
Sensor Box Insulation Pattern- DP
*This indicates an experimental redundancy.
non-transparent lid,uninsulated*
non-transparent lid,pink insulation*
non-transparent lid, white insulation*
Battery
2nd Deployment
Experimental Design- DP
*This indicates an experimental redundancy.
2 6 18* 15 28* 9 12*
3 7 19* 16 29* 10 13*
4 8 20* 17 30* 11 14*
Alkaline Battery NiMH Battery Lithium Ion Battery
2nd Deployment
Results & Discussion
Time (sec)
Time (sec)
2nd DeploymentAlkaline
•All alkaline battery graphs were essentially the same.
Results & Discussion
Time (sec)
Time (sec)
2nd DeploymentNiMH
•Non-transparent & pink insulated boxes- similar graphs•Box #10: greater lifespan (3.82 days)
Results & Discussion
Time (sec)
Time (sec)
2nd DeploymentLi Ion
•Pink & white insulated boxes- similar graphs•Box #8: greater lifespan (3.99 days)
•Peak internal temperature of all the nontransparent lid sensor boxes was the same•Try thicker insulation in larger sensor box
•Foil-faced polystyrene foam insulation•Difference in lifespan of NiMH batteries•No effect in lifespan of alkaline batteries•Shortened lifespan of lithium ion batteries
•Overall, the alkaline battery’s charge lifespan was the greatest of all with insulation or without•
Conclusions & Recommendations
•Direct sunlight conditions •Discovery Park and Water Treatment site•Recommend NiMH batteries•Solar panel recharge device
•Shaded conditions •Greenbelt site•Recommend alkaline batteries•Lifespan is the longest
Conclusions & Recommendations
Future Work: Winter Temperatures•We did not have time to conduct a winter temperature simulation with sensors in an ice chest
•We would like to run an experimental design identical to deployment 2 in Discovery Park in January• Extreme winter temperatures could have a greater effect on the lifespan of a battery’s voltage, as per manufacturer’s specifications
Dr. Murali VaranasiDr. Oscar GarciaDr. Miguel Garcia RubioDr. Miguel Acevedo Jue (Jerry) YangDr. Xinrong Li Ning (Martin) XuDr. Yan Huang Nitya KandukuriDr. Shengli Fu Mitchell Horton
The following people were instrumental in bringing us to UNT to conduct this research. We wish to thank them all for going far above and beyond the call of duty in assisting us with our project.
[1] Punn, Alex. “RE: Case Response for Case# 00004712.”E-mail to Donn Arnold. 16 July 2009.[2] Woodbank Communications Ltd. Battery and Energy Technologies: Thermal Management. 2005. 27 July 2009. <http://www.mpoweruk.com/
thermal.htm> .[3] Woodbank Communications Ltd. Battery and Energy Technologies: Performance Characteristics. 2005. 27 July 2009.
<http://www.mpoweruk.com/performance.htm>.[4] Procter & Gamble. Duracell: Alkaline Manganese: Technical Bulletin: Effect of Temperature. 2005. 28 July 2009. <http://www.duracell.com/oem/
primary/alkaline/ alkefftemp.asp.>[5] Energizer Holdings, Inc. “Alkaline Manganese Dioxide: Handbook and Application Manual.” Energizer: Alkaline Handbook: Version: Alk1.3. 2008. 28 July 2009. <http://data.energizer.com/Static.aspx?Name=AppManuals>. Path: Battery Handbooks; Alkaline.
Works Cited
[6] Procter & Gamble. Duracell: Nickel Metal Hydride: Technical Bulletin. 2009. 28 July 2009. <http://www.duracell.com/oem/rechargeable/Nickel/
nickel_metal_tech.asp>.[7] Buchmann, Isidor. Discharging at High and Low Temperatures. 2003-2005. 29 July 2009. <http://www.batteryuniversity.com/partone-15.htm>.[8] Fetcenko, M.A., et al. “Recent advances in NiMH battery technology.” Journal of Power Sources. 165 (2007) 544-551.[9] Kopera, John J.C.. “Inside the Nickel Metal Hydride Battery.” 25 June 2004. Cobasys. 29 July 2009. <www.cobasys.com/pdf/tutorial/
inside_nimh_battery_technology.pdf>.[10] McKissock, Barbara, et al. “Guidelines on Lithium-Ion Battery Use in Space Applications.” March 2008. NASA Engineering Safety Center Battery Working Group. 30 July 2009. <http://ntrs.nasa.gov/archive/nasa/
casi.ntrs.nasa.gov/20090023862_2009023573.pdf>.
Works Cited
[11] Buchmann, Isidor. Is lithium-ion the ideal battery?. 2003-2005. 30 July 2009. <http://www.batteryuniversity.com/partone-5.htm>.[12] “AA Portable Power Corp: Product Specification: Lithium/Iron Disulfide.” 3 Aug. 2009. < http://www.batteryspace.com/index.asp?PageAction
=VIEWPROD&ProdID=1397>. Path: 1.5V 2900mah Lithium AA.[13] Bannister, Kenneth, Gianni Giorgetti, and Sandeep K.S. Gupta. “Wireless Sensor Networking for “Hot” Applications: Effects of Temperature on Signal Strength, Data Collection and Localization.” IMPACT Lab, Arizona State University. 16 July 2009. <http://impact.asu.edu>.[14] Novak, Keith S., et al. “Mars Exploration Rover Surface Mission Flight Thermal Performance.” July 2005. Jet Propulsion Laboratory, California Institute of Technology. 31 July 2009. <http://hdl.handle.net/2014/37436>.
Works Cited
[15] Capozzo, Daniel, et al. “Lithium Ion Battery Safety.” 14 Dec. 2006. Worcester Polytechnic Institute. 31 July 2009. < http://www.wpi.edu/Pubs/E- project/Available/E-project-121306-105357>.[16] Park, Chulsung, Kanishka Lahiri, and Anand Raghunathan. “Battery Discharge Characteristics of Wireless Sensor Nodes: An Experimental Analysis.” March 2005: 0-7803-9011-3. IEEE. University of North Texas. 3 Aug. 2009. < http://ieeexplore.ieee.org/Xplore/guesthome.jsp>.[17] Yang, Jue, et al. “Integration of Wireless Sensor Networks in Environmental Monitoring Cyber Infrastructure.” College of Engineering, University of North Texas.
Works Cited