Date post: | 08-Apr-2016 |
Category: |
Documents |
Upload: | designplan-lighting-inc |
View: | 224 times |
Download: | 0 times |
NEW 2015Dorothy
79 Trenton Avenue Frenchtown, NJ 08825
Tel: (908) 996-7710 Fax: (908) 996-7042
66
Dorothy LEDDesign by Ares Concept Registered Community Design
• LED bollard for installation outdoor• Configuration: die-cast aluminum structure. EN AB 47100 alloy (low
copper content)• Double layer coating for high resistance to corrosion: The low copper
aluminum alloy is painted with a double coat using powders which are complaint with QUALICOAT standards: a first layer of epoxy powder (with excellent chemical and mechanical resistance) and a second finishing layer of polyester powder (resistant to UV rays and atmospheric agents).The entire painting process of the aluminum fitting starts from components which have been sand-blasted in advance to make the surface more porous and increase the adherence of the paint. Ares effects alkaline and acid washing to clean the surfaces completely, then rinses with demineralised water to remove any residue particles, subsequently a chemical conversion treatment is done to protect against rusting.
• Transparent polycarbonate diffuser and expanded neoprene gaskets• Protection Rating: IP66• Installation: the luminaire is equipped with two EPDM cable glands
(0.3"<ø<0.5" cable). Outdoor use requires suitable flexible cables assuring the watertightness of the cable gland. Direct screwing on a solid surface or ground fixation through base plate and bolts (to be ordered separately).
1. White 2. 9. Rust-red Aluminum 3. Anthracite 4. Black
Bollard Light The fitting is equipped with 2 cable input
Glow wire test: 650°CProtection againstimpactIK 07 - 2,00 joule
Full cut-off luminaire (no light pollution)
2015
C0 / C180 C90 / C270
cd / 1000 lm -5.56'-13.1' 5.56'0' -5.56'
5.56'
0'
Lux
60
30060˚
90˚
120˚
145
5
20
MID-POWER LED
Incorrect Fixing MethodCorrect Fixing Method Correct Fixing MethodBollard �xed on plinth + plug Bollard �xed on plinth + �xing bolts Do not �x the bollard directly on the ground
Ø 8.54"
12.80"
U537001 A A+ A++ COOL WHITE 6000KMID-POWER LEDs 10W/120-277vACTotal power 11W LED lm 1200 ≠ FIXT lm 1052 CRI >70
U537002 A A+ A++ NATURAL WHITE 4000K MID-POWER LEDs10W/120-277vACTotal power 11W LED lm 1100 ≠ FIXT lm 964 CRI >80
U537003 A A+
WARM WHITE 3000K MID-POWER LEDs10W/120-277vACTotal power 11W LED lm 1050 ≠ FIXT lm 921 CRI >80
Dorothy Mid-Power LED
Accessories: Dorothy LED
U200BASE PLATE AND FIXING BOLTS Ø 4.72" x H 6.30"
6.30
"Ø
4.72"
2015
79 Trenton Avenue Frenchtown, NJ 08825
Tel: (908) 996-7710 Fax: (908) 996-7042