(877) 634-0982 www.digipwr.com
Product Specification DC/DC Converters
Key Product Features
• Fully isolated input• Up to 4 outputs• 75% efficiency• Input EMI filter• 5" x 3.3" x 1.5" size• UL, cUL and CE approved• Optional cover• Available with 90-264VAC universal input
DP100 Series 100 Watt
Model Options
DP100-105
DP100-112 0A
DP100-124
DP100-201 0.5A
0A
DP100-301 0.5A
0A
DP100-303
0A
0A
0A
0A
0.5A
Model Number1 Output Voltage Min2Output Current Ratings
Max3 Max4 Peak5Output
DP100-401 0.5A
0A
0A
Modified standard
flexibility output options60.5A
0A
0A
0A
0A
0A
V1
V1
V2
V1
V3
V2
V1
V2
V1
V1
V1
V3
V4
V1
V3
V3
V2
V2
V4
+12V
+5V
+12V
+5V
-12V
+15V
+5V
+12V
+24V
+5V
+5V
-12V
-5V
±3.3V to ±48V7
±2.0V to ±48V8
-15V
±2.0V to ±48V8
+12V
±2.0V to ±48V8
6.5A
8.0A
4.0A
8.0A
1.0A
10.0A
4.0A
3.0A
8.0A
8.0A
1.0A
1.0A
1.0A
4.0A
4.0A
8.0A
10.0A
6.0A
10.0A
2.0A
6.0A
15.0A
6.0A
4.0A
10.0A
10.0A
2.0A
2.0A
15.0A
2.0A
1.0A
6.0A
6.0A
1.0A
10.0A
16.0A
7.0A
12.0A
2.5A
7.0A
20.0A
7.0A
4.5A
12.0A
12.0A
2.5A
2.5A
2.5A
7.0A
1- DP100-XXX = 48VDC input. DM100-XXX = 24VDC input. 2- At least 20% of max output current is required to maintain stated regulation3- Convection cooling. DM ratings slightly lower. Contact the factory4- Forced air cooling. DM ratings slightly lower. Contact the factory
5- Peak output, 30 sec max6- The DP100 series allows very fast flexible modified standard designs within these parameters without non-recurring engineering charge and while retaining safety agency approval. Please contact the factory for details 7- Can be specified in 0.1V increments8- Can be specified in 0.75V increments
DescriptionThe DP100 series are open frame DC/DC converters ideal for systems powered from a 24VDC or 48VDC source. These converters deliver up to 100W of continuous or 120W peak power from one to four outputs.
The DP100 is one of the flexibility series. In addition to the popular models listed on this sheet, thousands of potential other modified standard models are available that include full safety agency approval and do not require any non-recurring engineering (NRE) charge. Prototype delivery is typically just a few weeks.
Flexibility options include a cover. Output voltage options are given in the table below. Fully custom models are also available. Please contact the factory for details.
All DP100 models are also available with 90-264VAC univeral input. Please see the US100 data sheet for details.
DP100 Series
Environment
Operating Temperature Range (full power) 0ºC to 50ºC
Operating Temperature Range (extended range) 0ºC to 70ºC Derate linearly from full power at 50ºC to half power at 70ºC
Storage Temperature Range -25ºC to +85ºC
Relative Humidity 5% to 95%, non-condensing
Vibration 0.75G peak, 5Hz to 500 Hz. Test three orthogonal axes at 1 octave/min, 5 min dwell at four major resonances
Specifications
Input Voltage Range 20-36VDC (24V nominal - DM series) ; 36-72VDC (48V nominal - DP series)
Input Surge Current 25A max, cold start
OutputOutput Power
Line Regulation
Load Regulation
Cross Regulation ±0.5% (V1, 20% to 100% I0 on V2-V4) ; ±5% (V2-V4, 50% to 100% I0 on V1)
75% typ at nominal line, full power
100W, 28CFM forced air ; 120W peak
±3% (V1, 20% to 100% I0) ; ±5% (V2-V4, 20% to 100% I0)
Input
Noise and Ripple 25mV max RMS, 100mV max P-P on V1 with full load. 95-264VAC ; 0.5% max RMS, 1% max P-P on V2-V4 with full load. 95-264VAC
Overshoot 5% max, all outputs
Transient Response for 25% to 75% I0 change, 5% max deviation, with recovery to 1% within 500µS
Hold-Up Time 6mS, 115VAC input, full output power
Overvoltage Protection Threshold 30% V0, all outputs
Power Foldback Point
±0.2%, Vin (min) to Vin (max)
Note: Specifications are typical at 25°C unless otherwise stated
120% of max rated power
Efficiency
DP100 Series
Mechanical Drawing
48430 Lakeview Blvd., Fremont, CA 94538, USA
T: (877) 634-0982 | F: (510) 657-6634 [email protected]
Digital Power Corporation | USA
www.digipwr.com | (877) 634-0982
Gresham Power Electronics | UK/Europe Telford
Rd, Salisbury, Wiltshire SP2 7PH, UK
www.greshampower.com | +44 (0)1722 413 060
Digital Power Corporation designs and manufactures flexible power supply solutions for the most demanding applications in the defense, healthcare, telecom, and industrial markets. With headquarters in Fremont, California, Digital Power is publically traded on the NYSE (symbol: DPW). The company was founded in 1969 incorporated in California.
DP50_09-11-07