Dremel MultiPro 395 Casing ReplacementSometimes, the casing will get damaged when you use the MultiPro often.

Written By: Matthew Satton

Dremel MultiPro 395 Casing Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 7

INTRODUCTION

This guide will show how to replace damaged casing on the Dremel MultiPro 395.

TOOLS:T15 Torx Screwdriver (1)

Dremel MultiPro 395 Casing Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 2 of 7

http://www.ifixit.com/tools/t15-torx-screwdriver/if145-084-2

Step 1 — Casing

Remove the blue caps located on either side of the MultiPro, using a 3 mm flathead screwdriver.

Step 2

Carefully remove the carbon brushes attached at the end of the springs by gently pulling on thesprings using your hands.

Dremel MultiPro 395 Casing Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 3 of 7

Step 3

Pull one side of the hanger up and then pull away from the Multipro until the other side can bepulled out.

Step 4

Remove the 4 screws located on the bottom of the Multipro with a T15 screwdriver.

Dremel MultiPro 395 Casing Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 4 of 7

Step 5

Hold down the collet lock, remove the chuck cap from the top of the Multipro by screwingcounterclockwise.

Step 6

Remove the black housing cap from the Multipro located directly below the chuck cap.

Dremel MultiPro 395 Casing Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 5 of 7

Step 7

Pull the bottom side of the casing up to remove it.

Step 8

Gently lift the motor shaft out of the Multipro.

Dremel MultiPro 395 Casing Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 6 of 7

To reassemble your device, follow these instructions in reverse order.

This document was last generated on 2017-06-21 07:55:17 PM.

Step 9

Pull the lock pin and its casing out of the other side of the Multipro case.

Dremel MultiPro 395 Casing Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 7 of 7

Dremel MultiPro 395 Casing ReplacementWritten By: Matthew SattonINTRODUCTION

TOOLS:Step 1 — CasingStep 2Step 3Step 4Step 5Step 6Step 7Step 8Step 9