DSI connector is on board on the RPI. Some graphical LCD/OLED displays might be attached to it.

JTAG-programmer for Xilinx CPLDs/FPGAs, C2-programmer for SiLabs C8051F

The LEDs have the following meanings : ACT – D5 (Green) – SD Card Access PWR – D6 (Red) – 3.3 V Power is present FDX – D7 (Green) – Full Duplex (LAN) connected LNK – D8(Green) – Link/Activity (LAN) 100 – D9(Yellow) – 100Mbit (LAN) connected

BTW: The Pi works with Kantronics KPC3+ too using Minicom for Packet

startx

Change the keyboard to US

BASIC Raspbian (Wheezy) Linux Commands

sudo su sudo raspi-config

startx apt-get install synaptic

apt-get update

apt-get upgrade

apt-get disti-upgrade

ls

lsusb

alsamixer, alsaplayer

chmod

halt, reboot, reload

nano

sudo raspi-config

apt-get check

apt-get –f install

apt-get autoclean

apt-get autoremove

cd

dpkg, wget,

man apt-get

If you mess up, then reboot, and hit shift key and reinstall Rasbian (Wheezy)