+ All Categories
Home > Documents > Ducati Monster 797 S U P P L E M E N T A R Y M A N U A L · S U P P L E M E N T A R Y M A N U A L...

Ducati Monster 797 S U P P L E M E N T A R Y M A N U A L · S U P P L E M E N T A R Y M A N U A L...

Date post: 07-Jun-2020
Category:
Upload: others
View: 0 times
Download: 0 times
Share this document with a friend
3
Ducati Monster 797 2017- Remove the seat. www.healtech-electronics.com S U P P L E M E N T A R Y M A N U A L for iQSE-1 + QSH-F2D PAGE 1/3 Lift up or remove the fuel tank. Locate the fuel injector connectors. (Black, 2-pole connectors under the airbox.)
Transcript
Page 1: Ducati Monster 797 S U P P L E M E N T A R Y M A N U A L · S U P P L E M E N T A R Y M A N U A L for iQSE-1 + QSH-F2D Mount the QSE Sensor. (Replace the bolt with the one supplied.

Ducati Monster 7972017-

Remove the seat.

www.healtech-electronics.com

S U P P L E M E N T A R Y M A N U A Lfor iQSE-1 + QSH-F2D

PAGE 1/3

Lift up or remove the fuel tank.

Locate the fuel injector connectors.

(Black, 2-pole connectors under the airbox.)

Page 2: Ducati Monster 797 S U P P L E M E N T A R Y M A N U A L · S U P P L E M E N T A R Y M A N U A L for iQSE-1 + QSH-F2D Mount the QSE Sensor. (Replace the bolt with the one supplied.

www.healtech-electronics.com PAGE 2/3

Connect the QSH black wire terminal to the negative terminal of the battery.

Plug the QSH connectors in-line with the fuel injector

connectors.

Before mouning the QSE Sensor install the sensor

componentsin the following order:

Bolt head -Sensor -Spacer -

Ducati Monster 7972017-

S U P P L E M E N T A R Y M A N U A Lfor iQSE-1 + QSH-F2D

Page 3: Ducati Monster 797 S U P P L E M E N T A R Y M A N U A L · S U P P L E M E N T A R Y M A N U A L for iQSE-1 + QSH-F2D Mount the QSE Sensor. (Replace the bolt with the one supplied.

www.healtech-electronics.com PAGE 3/3

Typical position for theQuickShifter easy.

Secure the module properly.

Ducati Monster 7972017-

S U P P L E M E N T A R Y M A N U A Lfor iQSE-1 + QSH-F2D

Mount the QSE Sensor.(Replace the bolt with the one supplied.

Tighten the bolt inthis position by about 5-6 Nm. If you do not

havea torque wrench, tighten the bolt until the

shift arm is tight on the gearbox shaft.For different mounting options,

refer to the sensor install guide.)


Recommended