Date post: | 04-Nov-2015 |
Category: |
Documents |
Upload: | psicosis3000 |
View: | 238 times |
Download: | 1 times |
Dummy Load
Using five (5) 50K Ohm power resistors
DALE RS-10 50K Ohm 1%
Build your own Dummy Load Connect the five (5) 50 K ohm resistors
In series, then label the connection points A ~ E
A B = 100 K Ohms
A C = 150 K Ohms
A D = 200 K Ohms
A E = 250 K Ohms
The Dummy Load can be used for troubleshooting the backlight inverter power
supply, by substituting for a single CCFL bulb on any one of the outputs on a
multiple output backlight inverter supply.
Always remove the power before substituting the CCFL output with the resistor
dummy load.
(I would) Connect a test clip lead from connection A on the resistor Dummy Load to
the ground return point for all the CCFL bulbs to the inverter supply.
(Then I would) Connect the second lead from connection points C to the inverter
output in which the plug was removed
Now apply power to the LCD and test the inverter power supply output.
Build a second resistor dummy load so you can substitute another output on the
invert power supply.
A to B = 100 K
Ohms
A to C = 150 K
Ohms
A to D = 200 K
Ohms
A to E = 250 K
Ohms
A to F = 300 K
Ohms
A to G = 350 K
Ohms