1/32 scale detail set for Trumpeter kit • sada detailù pro model 1/32 Trumpeter
1/3 33 087
33 087
Su-25 Frogfoot interior S.A.
SYMETRICAL ASSEMBLYSYMETRICKÁ MONTÁZ ´ ́
REMOVEODSTRANIT
OPTIONVOLBA?
REPLACENAHRADIT
BENDOHNOUT
GRINDOBROUSIT
ORIGINAL KIT PARTSPÙVODNÍ DÍLY STAVEBNICE
PHOTO-ETCHED PARTSLEPTANÉ DÍLY
PARTS TO BE REMOVEDDÍLY K ODSTRANÌNÍ
FILLTMELIT
eduard
L12
4
20
19
18
8
2 pcs
3 pcs18
19
3 pcs19
L13
320
19
18
31
l = 3mm
plastic= 2mm
l = 3mm
plastic= 1mm
25
24
33
21
L10
L17
2 pcs
22L9
K22
23
18
19
38
2/3 33 087
B1
1
2
34
18
19
10
27
L12, L13, Q9
192 pcs
L3
A2
13
12
29
7
l = 8mm
2 pcs plastic= 1mm
14
6
26
5
37
11
A1
Q10
12
16
18
15
2 pcs
12
12
39
30
32 36
Made in Czech RepublicEduard M.A. © 2011 www.eduard.com
2. Do not inadvertently place etched componets on an unwanted surface. Attempts to remove will result in damage to your part.
2. Nepokládejte samolepící díly na volné plochy. Pokud je omylem pøilepíte, pøi pokusu o odlepení dojde k poškození dílu.
1. Separate the etched components from their frames on the protective paper. Removal from the paper is done only after separation of the parts from the frames.
1.Samolepící díly oddìlujte od rámeèku na podkladovém papíøe. Po oddìlení je sejmìte z krycího papíru.
3. Do not touch the adhesive areas of the etched components.
3. Nesahejte na èásti dílù, na kterých je naneseno lepidlo.
4. Hold the parts by the edges, or at areas free of adhesive.
4. Samolepící díly berte za hrany nebo za èásti, na kterých není nanesené lepidlo.
5. Lightly place the component in the desired location and position. Adjust as required. The component will by permanently affixed when pressed onto its intended location, its location can be adjusted.
5. Díl lehce položte do pozice, ve které má být nalepen. Upravte pøesnou pozici a pøimáèknìte. Díl dokonale pøilne až po pøimáèknutí, pøed pøimáèknutím lze dílem opatrnì manipulovat.
PARTS WITH GLUE DÍLY OPATØENÉ LEPIDLEM
3/3 33 087
S2
28
9
35 17