www.lasertools.co.uk
7272
Distributed by The Tool Connection Ltd
Kineton Road, Southam, Warwickshire CV47 0DRT +44 (0) 1926 815000 F +44 (0) 1926 [email protected] www.toolconnection.co.uk
If this product fails through faulty materials or workmanship, contact our service department direct on: +44 (0) 1926 818186. Normal wear and tear are excluded as are consumable items and abuse.
Guarantee
Electric Drum Pump - AdBlue® - Euro Plug
www.lasertools.co.uk
PrecautionsOur products are designed to be used correctly and with care for the purpose for which they are intended. No liability is accepted by the Tool Connection for incorrect use of any of our products, and the Tool Connection cannot be held responsible for any damage to personnel, property or equipment when using the tools. Incorrect use will also invalidate the warranty.
If applicable, the applications database and any instructional information provided has been designed to offer general guidance for a particular tool’s use and while all attention is given to the accuracy of the data no project should be attempted without referring fi rst to the manufacturer’s technical documentation (workshop or instruction manual) or the use of a recognised authority such as Autodata.
It is our policy to continually improve our products and thus we reserve the right to alter specifi cations and components without prior notice. It is the responsibility of the user to ensure the suitability of the tools and information prior to their use.
7272_Instructions_V7
AdBlue® is a registered trademark of the Verband der Automobilindustrie e.V. (VDA)
Electric pump for AdBlue® dual power mains/12volt 3m dispensing hose and swivel spout.
Compact and lightweight construction.
Convenient On/Off switch with LED indicator.
Designed to fi t 205L/45 UK gallon drums and IBC tanks.
For connection to IBC tanks equipped with DN150 screw access use with adaptor 60527. Two further adaptors supplied for Mauser and Tri-Sure.
Dual power: Mains or 12 volt giving a fl ow rate of 19 litre per minute/5 gallons per minute.
Also suitable for water based liquids such as antifreeze and windscreen washer fl uids (for diesel and light oils use 7273).
Supplied with 3m hose and swivel dispensing nozzle (ISO 22241 compliant), drum fi tting 2" BSP.
Duty cycle: 15 minutes on/15 minutes off.
Wetted ComponentsViton, Stainless Steel, PE, PP.
Recommended UseAdBlue®, water based media, antifreeze, detergents, pesticides, herbicides, urea and weak acid/base chemicals.
DO NOT USE WITHHighly fl ammable liquids, gasoline, petrol, corrosive chemicals, lacquer thinners, any material that is not compatible with the pump contruction.
Specifi cation
Motor Type DC Brush Motor (5 Pole)
Temperature 5° to 40ºC (41° to 104°F)
Maximum Viscosity of Media 100 cst
Power Source DC Power AC Power
Power cord 3m long with crocodile clip AC to DC power adaptor
Voltage 12V DC 200-240V AC, 50/60 Hz
Maximum discharge 19 LPM
Features
Deliversupto
19 LPM
12V DCBattery Cable
Extra Cap Adaptor for use with IBC Tank - AdBlue®
Part No. 60527
Euro PlugPart No. 605262 Pin
Mauser and Tri-Sure Adaptors
Instructions
Insert the pump into the drum through the drum hole
Switch on the toggle switch (up)
Take off the nozzle from drum
Screw pump into drum
Pull the trigger
After dispensing switch off the toggle switch (down) and lift the nozzle upward allowing all the liquid in the line to fl ow back into the drum
Place the nozzle into the receiving container to transfer the liquid
Switch off when fi nished transfer of fl uid
Place the nozzle back into the holster to prevent any damage to the hose or to the nozzle
1 2 3
4 5 6
7 8 9
1. Rotate the joint nut anticlockwise and then pull thestrainer end of the suctiontube away from the bung.
2. After extending the suctiontube rotate the joint nutclockwise to fi x the suctiontube in the extendedposition.
Lift HandleManual Dispensing Nozzle
Thread Converter (with 2.5" x 5mm Butress Threads)
Telescopic Suction Tube
Flexible Corrugated Hose 2m long
On/Off Switch
Pump Outlet with Swivel Connection