Date post: | 02-Jan-2016 |
Category: |
Documents |
Upload: | kenyon-hendrix |
View: | 21 times |
Download: | 0 times |
1
Embedded Stroke Evaluation System
Amanda Sweeney, 4ECE
Supervisor: Martin Glavin
2
Presentation Overview
• Project Description
• Progress to Date
• Work Remaining
3
Project Description
• This project involves the development of an embedded system that will allow an occupational therapist to objectively and accurately measure the severity of stroke suffered by patients in their care
• The system will measure and record pressure, force, position and speed of the wrist action, to allow the therapist to assess the severity of the stroke
4
Progress to Date
• Strip Board - Design & Build
• Voltage Regulator Circuit - Design & Build
• Connecting LCD to MPU - IDE cables
• Programming the LCD - To display text
5
Printed Circuit Board
• Strip Board Components– 3 FSR’s– 3 83 0hm Resistors– 9V Battery
• The sensors operate as a component of a voltage divider circuit
• The outputs from the circuit are transmitted to an ADUC831 circuit board
6
Voltage Regulator Circuit
• A voltage regulator is an electrical regulator designed to automatically maintain a constant voltage level.
1. Input : Unregulated Voltage 2. Ground 3. Output: Regulated voltage
7
Connecting LCD to MPU
• IDE cables to connect the pins on the LCD to the MPU made up according to pin assignment in T6963C datasheet
8
Programming the LCD …
• After power on it is necessary to drive RST low for a minimum of 2 microseconds to ensure proper reset of the T6963C.
• Initialize LCD
– The controller must then be initialized with a series of commands to set up the various modes and options available to the user.
9
… Programming the LCD
• Status Check
– Before every data read, data write or command write the status of the LCD must be checked to ensure that it is ready to communicate with the MPU.
– This means simultaneously checking the status of STA0 and STA1 i.e. D0 and D1 respectively, both of these must be “1” to enable command execution capability and data read/write capability.
10
… Programming the LCD …
Data Transmission
11
… Programming the LCD
30h, 32h, 25h, 33h, 33h, 35h, 32h, 25h, 1Ah
12
Work Remaining …
• ADC
• Serial Communication
• Integrate Keypad and Buzzer
• Position & Speed of Wrist Action
• GUI
13
Questions ???