2

Eng Seng Cement Products Pte Ltdenhancing the building industry since 1961

2

3

TYPICAL PAVEMENT TYPICAL BLOCK TYPICAL BASECOURSE REQUIREMENTS APPLICATION THICKNESS(MM) TYPE OF MATERIAL THICKNESS (mm)

(i) Light to medium duty e.g. Footpaths, jogging, 80MM tracks, residential driveways

(ii) Heavy duty

container yards, aircraft parking aprons

100 to 200 mm

225 to 600 mm

225 to 600 mm

(a) Quarry dust (footpaths)

(b) Crusher run (driveways)

(c) Crusher run (road & container yards)

(d) Lean concrete (very heavy concentared roads)

3

GENERAL INFORMATION

The thickness and design of a concrete segmental pavement is subject to:

> Soil & subgrade investigation> Surface design> Basecourse thickness design> Design considerations for low-strength subgrades or irregular shaped areas

COMPRESSIVE STRENGTH80MM - 49MPa100MM - 49MPa

TOLERANCEThickness of any paver shall be ±3mm

Basecourse Talking the existing sub-grade / soil conditions and

Sand Bedding LayerA layer of sand should be loosely spread and screeded to a uniform thickness such that its compacted thickness would be approximately 30mm. It is important that the sand layer remains undisturbed prior to the laying of blocks.

Laying The Blocks Paving blocks are placed side by side on the sand bed with gaps of approximately 2mm between adjoining blocks.

Blocks Cut And Fit Paving blocks can be cut to fit and awkward corners

Pavement CompactionBlock pavement is compacted with a hand -guided plate vibrator until it is embedded in the sand layer.

5

Type C7, C7A, C8, C8A, C8B

6

Residential - Low rise Commercial / IndustrialResidential - High rise

Strength & Robustness

Product Performance

Sound Transmission Clss

Initial Surface Absorptionand Carbonation Test:

Fire Resistance:

SS

Product P

SSS

Iaaa

F

better control of

Material

Ferroconcrete

Panel Dimensions

R id ti l L i C i l / I d t i lR id ti l Hi h i

High Quality Finish, Concealed Services

Steel tie plateFastener

FerroLite PartitionWall System

7

Cert.No: N483303 Cert.No: 022-024