Date post: | 05-Feb-2016 |
Category: |
Documents |
Upload: | andik-manchesterunited |
View: | 225 times |
Download: | 0 times |
Ethernet Service OAM LB Testing.
1. Create PWE3 E-Line service. Note the V-LAN ID, will be used for LB Test later.
2. Create new MD. Maintain MD level as 4.
3. Create MA. Select the E-LINE Service just created.
4. Create MEPs.
5. Create Remote MEP in an MA.
6. Key in remote end MEP ID.
7. Do the same setting at Remote End. Then perform LB testing. Chg MP ID as remote End
MEP ID.
8. Then start test LB.
9. If select Dest. MP MAC Address, copy remote end eth port MAC address.
10. Perform LT testing by MP ID, chg remote MP ID.
11.Or by Dest. MAC address, copy remote end Eth port MAC address.
PW Ping test verification
---- PW Ping Response ----
PW ID : 1
LSRID : 1.1.1.4
Packet Size : 64
Sequence ID : 1
Delay(us) : 22721
TTL : 255
Return Code : Replying router is an egress for the FEC at stack-depth
Sub-code : 1
---- PW Ping Response ----
PW ID : 1
LSRID : 1.1.1.4
Packet Size : 64
Sequence ID : 2
Delay(us) : 15628
TTL : 255
Return Code : Replying router is an egress for the FEC at stack-depth
Sub-code : 1
---- PW Ping Response ----
PW ID : 1
LSRID : 1.1.1.4
Packet Size : 64
Sequence ID : 3
Delay(us) : 16110
TTL : 255
Return Code : Replying router is an egress for the FEC at stack-depth
Sub-code : 1
---- PW Ping Statistics ----
PW ID : 1
Total of TX : 3
Total of RX : 3
Lost Rate(%) : 0
Min Delay(us) : 15628
Max Delay(us) : 22721
Avg Delay(us) : 18153