+ All Categories
Home > Documents > EVAPORATIVE COOLING FOR AIR HANDLING UNITS · Humidification and Evaporative Cooling EVAPORATIVE...

EVAPORATIVE COOLING FOR AIR HANDLING UNITS · Humidification and Evaporative Cooling EVAPORATIVE...

Date post: 12-May-2018
Category:
Upload: lemien
View: 247 times
Download: 7 times
Share this document with a friend
4
Humidification and Evaporative Cooling EVAPORATIVE COOLING FOR AIR HANDLING UNITS Low energy and low cost cooling with adiabatic humidifiers
Transcript
Page 1: EVAPORATIVE COOLING FOR AIR HANDLING UNITS · Humidification and Evaporative Cooling EVAPORATIVE COOLING FOR AIR HANDLING UNITS Low energy and low cost cooling ... Evaporative cooling

Humidification and Evaporative Cooling

EVAPORATIVE COOLINGFOR AIR HANDLING UNITSLow energy and low cost coolingwith adiabatic humidifiers

Page 2: EVAPORATIVE COOLING FOR AIR HANDLING UNITS · Humidification and Evaporative Cooling EVAPORATIVE COOLING FOR AIR HANDLING UNITS Low energy and low cost cooling ... Evaporative cooling

For every kilo of humidificationdelivered from an adiabatic humidifier 0.68kW of evaporativecooling is achieved.

As a single adiabatic humidifier can provide up to 1,000kg/h ofhumidification and a resultant 680kWof evaporative cooling, while operatingon as little as 0.3kW of electricity, their potential for delivering low cost, low energy cooling to an air handling unit is great.

THE POTENTIAL OF EVAPORATIVE COOLING

1kg evaporatedwater = 0.68kW evaporative cooling

EVAPORATIVE COOLING SOLUTIONSCondair manufactures a comprehensive range of evaporative cooling systems for all types of air handling unit.

This specialist range is combined withextensive expertise in the industry toensure Condair always recommendsand provides the most appropriate

solution for any air handling unitevaporative cooling project.

Condair ME evaporative humidifier Condair HP high pressure humidifier Condair DL hybrid humidifier

Page 3: EVAPORATIVE COOLING FOR AIR HANDLING UNITS · Humidification and Evaporative Cooling EVAPORATIVE COOLING FOR AIR HANDLING UNITS Low energy and low cost cooling ... Evaporative cooling

EVAPORATIVE COOLING STRATEGIESThere are three main strategies for evaporative cooling in air handling units.

Direct evaporative coolingHumidity is added to the incoming fresh air stream,reducing its temperature whilst increasing its humidity.This conditioned air is supplied directly to the room with ahigh percentage of the room air being exhausted, ratherthan re-circulated, to maintain an appropriate humiditylevel in the room.

The amount of cooling that can be achieved depends uponthe humidity level of the incoming air stream. Air with alower humidity will absorb more moisture, resulting in agreater evaporative cooling effect.

Indirect evaporative coolingOutside air is used to cool an internal environment withoutany mixing of the internal and external air streams. Outsideair is run through a heat recovery (HR) unit and is thenexhausted. The return air from the room is cooled by the HR unit before being reintroduced to the room.

By humidifying the external air stream prior to the HR unit,its temperature is reduced, enhancing the cooling capacity of the system. This enables indirect evaporative cooling to be used when the outside temperature is higher than thedesired room supply condition. A higher velocity on theexternal air stream than the internal further increases thecooling capacity of the system.

Exhaust air evaporative cooling The return air extracted from the room is cooled by thehumidifier before being run through a HR unit and thenexhausted outside. The cool thermal energy provided by thehumidifier is transferred to the incoming air stream by theHR unit, cooling it and reducing the required load on DX airconditioning systems.

As there is no mixing of the humidified exhaust air and theincoming fresh air, there is no moisture added, so coolingoccurs irrespective of the incoming air's humidity level.

Outside air

Outside air

Outside air

Return air

Return air

Return air

Humidifier

Humidifier

Humidifier

Heat recoveryunit

Heat recoveryunit

Supply air

Supply air

Supply air

Exhaust air

Exhaust air

Exhaust air

Page 4: EVAPORATIVE COOLING FOR AIR HANDLING UNITS · Humidification and Evaporative Cooling EVAPORATIVE COOLING FOR AIR HANDLING UNITS Low energy and low cost cooling ... Evaporative cooling

Condair plc - the new name for JS HumidifiersArtex Avenue, Rustington, Littlehampton, West Sussex, BN16 3LN, UKTel: +44 (0)1903 850200 - [email protected] - www.condair.co.uk

06/2016

ASK FOR A FREE EXPERT CONSULTATION

Global expertise, local solutions

Condair adiabatic humidifiers areproviding economic cooling for clientsacross the world. From data centresand offices in the US to railway stationsand mosques in Saudi Arabia.

Condair has the experience andcomprehensive product range todeliver the most appropriate solutionfor any air handling unit’s evaporativecooling strategy.

Condair has the widest range of adiabatichumidifiers available with manufacturingfacilities in Asia, Europe and NorthAmerica, sales operations in 16 countriesand distributors in over 50 more.

Evaporative cooling systems aredesigned for each individualapplication by Condair’s experts tocreate the most effective and energyefficient solution. If required, Condair’sregional R&D departments can workwith a design consultant or an AHU

manufacturer’s design team to delivercustom systems.

Alongside this product range andexpertise, Condair’s specialisthumidifier engineering teams offerinstallation, commissioning andmaintenance support. This providesthe manufacturer’s knowledge directlyon-site and ensures the equipmentoperates efficiently and effectively formany years.


Recommended