Date post: | 30-Dec-2015 |
Category: |
Documents |
Upload: | lesley-hubbard |
View: | 216 times |
Download: | 0 times |
• This Webinar is LISTEN only
Questions will be answered in writing at the end of the
Webinar.
QUESTIONS?
Excavator X62 InstallationWebinar September 18th, 2009
• LS-B10W Laser Receiver Installation
•LS-B10W Verification
•TS-1 SensorsInstallation/Calibration 9-4-09 WebinarVerification 9-11-09 Webinar
LS-B10W Mounting
Where to mount the LS-B10W
Position the stick appropriately LS-B10W vertical
Determine LS-B10W LocationWhere on Stick to prevent damage
LS-B10W Laser Receiver Calibration
TS-1 Calibrated
0.0o House roll
Position LS-B10W vertical
Press Calibrate
LS-B10W Verification
Zero to Laser (laser on detector)
Elevation set point -6’
Verify bucket on string
Move machine and repeat
Wedge Error
Wedge errors or Inconsistent elevation errors:Perform Elevation Accuracy Verification to check machine and sensor calibration
TS-1 Sensor CalibrationImplement length
Depth to Center of Stick
Depth to center of stick:An error in this measurement would create an elevation error when the body of the machine is on a side slope.
Calibrate
Left of Pivot Line
Left of pivot line:An error in this measurement would create an elevation error when the stick is referenced at any angle other than vertical.
Calibrate
From Bucket Pivot
From bucket pivotAn error in this measurement would create an elevation error when the stick was in any position other that horizontal.
Calibrate
LS-B10W Angle Calibration
LS-B10W angle calibration:An error with this calibration would create and elevation error depending on the angle of the sensor when referencing the laser and the distance the laser is away from on-grade.
• Address to download all TU-Live Webinars: ftp://TUlive+topconuniversity.com:[email protected]/
– Recorded Webinar– PP Presentation– Webinar Q & A
• Additional requests for TU staff:
Email: [email protected]
Questions?