Expanded Metal Lath - Metal Arch Formers The easy way to create attractive and perfectly finished arches. 600mm 65mm 295 x 1200mm Verona with bridging sections Extra soffit section For walls of up to 160mm thick, the frame sections are designed to be overlapped. For walls 160-300mm thick, standard infill soffit pieces are provided to bridge the gap between the sections. If the thickness of the wall is between 300- 565mm, an Extra Soffit piece is available. Each arch is supplied with installation instructions and a complete fixing kit. Soffit pieces are also included for walls up to 300mm thick. Verona Brick to brick dimension 65mm Rise 60mm 140mm Extra soffit section
Transcript
Expanded Metal Lath - Metal Arch FormersThe easy way to create attractive and perfectly finished arches.
600mm
65mm
295 x 1200mm
Verona with bridging sections Extra soffit section
For walls of up to 160mm thick, the framesections are designed to be overlapped. Forwalls 160-300mm thick, standard infill soffitpieces are provided to bridge the gapbetween the sections.
If the thickness of the wall is between 300-565mm, an Extra Soffit piece is available. Eacharch is supplied with installation instructionsand a complete fixing kit. Soffit pieces are alsoincluded for walls up to 300mm thick.
www.catnic.comCare has been taken to ensure that the contents of this publication are accurate, but TataSteel Europe Limited and its subsidiaries, which includes Tata Steel UK Limited, do notaccept responsibility or liability for errors or information that is found to be misleading.Before using products or services supplied or manufactured by Tata Steel Europe Limitedand its subsidiaries, customers should satisfy themselves as to their suitability.
1 Measure the distancebetween the walls (brick tobrick) and select theappropriate arch size.If renovating, removeexisting plaster down to themasonry. Mark the centre ofthe aperture.
2 Position the first section ofthe arch to the wall and fixwith the masonry nailsprovided.
3 Fix the other sections in thesame way, aligning them atthe centre with the plasticjoining pieces provided. Allarches and soffit piecesshould be joined with the selftapping screws provided.
4 The arch is completed byplastering directly onto thesteel mesh, using a suitablematerial.
···
Quality: The galvanised steel used in the manufacture of mesh arch formers is in accordance with BS EN 10346: 2009 – DX51D+Z275.
