Click here to load reader
Date post: | 29-Jun-2015 |
Category: |
Technology |
Upload: | muhammad-khan |
View: | 143 times |
Download: | 1 times |
Click here to load reader
Specs: F-15 Park Jet3D Foamy
Loading
Area
Radio
Weight
4-5 Chanel
Thrust
Copyright © 2004 3DFoa All rights reserved.Designed and Drawn by:Steve Shumate & Levi JoUpdated: 0/19/2004
14-24 oz.
14-18 oz.
289.7 in2
6.5-8.6 oz/ft2
WWW.3DFOAMY.COM
Jet 3DFoamy.com.
rved.wn by: Levi Jordan04
Cut a "V" groovein foam forspars. Pull sparthrough grooveto make round
Start with the recomendedCG range. You can adjust itfurther back as you become
more familiar with the jet.
CG INFO
All hingingtape or acpoints epoand contro
nging for control surfaces can be packingor actual hinges. I prefer robart hinges epoxied in place for the added longivityontrol freeness. CA hinges work well also.
Sand the fuselage corners roundwith 80 grit sand paper,
then finish smooth with 200 and 400
Depron Rails
4
5
6
Prototype Setup/SpecsWing area: 289 sq in (effective area, which includSpan: 28.4 inLength: 41.7 inWeight RTF: 15.6 oz as shownWing loading: 8.2 oz/ft2 (based on effective wingMotor: GWS EPS-350 with “C” gearingBattery: 11.1V 1200 mAh LipoProp: GWS 8x6 SFCurrent draw: 9.7 ampsPower loading: 101 watts/lbRadio equipment: GWS R-6 receiver, GWS Pico aFlight controls: Wing flaperons, full-flying horizoMaterials used: Either 6mm Depron or BlueCore
sncludes the effect of the wing strakes)
wing area)
ico and Hitec HS-55 servos, 10 amp ESCorizontal stabilizer, twin ruddersCore fan fold foam
Pull PullPush/Pull
Cut Control horns from 1/32"
ply or a plastic coffee can lid.
Round LE, apply 3M 1" Satin tape for protection
1 2 3 4 5 6
1
2
3
Flight controls: Wing flaperons, full-flying horizoMaterials used: Either 6mm Depron or BlueCore
Foam Nose Cone
(CNC Cut, Sanded to shape)
orizontal stabilizer, twin ruddersCore fan fold foam
Vacu
(San
Vacuum Formed Canopy
(Sand from foam if scratch built)
www.3DFoam
Cut hatch after painting
for radio access
amy.com
Laser cut 1/4" birch motor block.
Epoxy into plane. DO NOT use CA on the moutor mount.
HS
-56
HB
k.
e t.