FEDIAF Code of practice
for the Manufacture of Safe Pet Food
TRAINING PACKAGE
Module VIII
Production
8. PRODUCTION
8.1 General requirements8.2 Feed materials of animal origin8.3 Weighing8.4 Mixing8.5 Quality control and product analysis8.6 Temperature/time control8.7 Foreign body detection8.8 Product release8.9 Control of non-conforming goods8.10 Quantity control8.11 Equipment and process validation8.12 Calibration8.13 Specific handling requirements8.14 Product packaging
PRODUCTION
8.1 General requirements8.2 ABPs feed materials
8.1 Clear responsibilities and production procedures in place One qualified employee responsible for production Production stages documented Take measures to ensure hygiene and safety
8.2 Use of ABPs must comply with EU legislation ABPs only from art. 6(a-j) of R1774/2002/EC Raw pet food must comply with microbiological criteria
8.3 Weighing8.4 Mixing
8.3 Accurate weighing equipment Appropriate devices and regular calibration A regular maintenance programme in place
8.4 Homogeneous mixture is essential Use appropriate mixers Clean the mixer to ensure product safety Mixers operate for a pre-set time (for homogeneity) Mixing efficiency regularly checked Prevent unacceptable carry over of undesirable substances
8.5 Quality control/analysis
8.5 Quality Control Plan (QCP) in place QCP identifies CCPs, sampling procedures, analysis
methods and measures to take in case of non-compliance Analytical testing Salmonella and Enterobac. tests Analysis by a competent laboratory
Critical Control Point
8.6 Temperature/time control
8.6 Temp. controlled, recorded Use alarm systems Canned pet food: Fc ≥ 3 Other than canned: ≥ 90°C Dog chews: sufficient heat to destroy pathogenic organisms
SterilisationPseudo D Value Plot at 121.1 C
for Cl. botulinum
0
1
2
3
4
5
6
7
0 0.25 0.5 0.75 1 1.25 1.5 1.75 2
Time in Minutes
Co
un
t o
f O
rgan
ism
Fc
8.7 Foreign body detection8.8 Product release
8.7 Identify, eliminate, minimise foreign body contamination Determine CCPs to avoid foreign body contamination Where necessary, install metal/foreign body detectors Corrective actions after detection shall be in place
8.8 Pet food is released by authorised personnel and following release procedures for each batch
Foreign body detector
8.9 Control non-conforming goods8.10 Quantity control8.11 Equipment/process validation
8.9 Out-of-specification identified, labelled , quarantined Corrective actions in place to avoid non-conformance8.10 Quantity checks to verify conformity with EU law8.11 Establish processing methods and validate product data
Control panel
8.12 Calibration8.13 Handling requirements
8.12 Equipments calibrated and records documented
8.13 Where packaging materials (glass) pose a risk, special handling procedures shall be in place
Records documented
8.14 Product packaging
8.14 Use proper packaging materials Packaging must conform with specifications Protect packaging surplus before store it again Packaging material is stored apart from raw materials
Finished product being transported