Publication 7000-IN011A-EN-P - April 2012

Installation Instructions

Ferrite Torroid Assembly

1. Open Ferrite Bead.

Figure 1 - Ferrite Bead Opened

2. Loop the ethernet patchcord around itself once, ensuring the loop is large enough to fit the length of the Ferrite bead.

Figure 2 - Looped patchcord

IMPORTANT The loop must be close to the end of the Ethernet patchcord that plugs into the Ethernet Switch.

Publication 7000-IN011A-EN-P - April 2012 Copyright © 2012 Rockwell Automation, Inc. All rights reserved. Printed in Canada.

Allen-Bradley, Rockwell Software, Rockwell Automation, and TechConnect are trademarks of Rockwell Automation, Inc.

Trademarks not belonging to Rockwell Automation are property of their respective companies.

Medium Voltage Products, 135 Dundas Street, Cambridge, ON, N1R 5X1 Canada, Tel: (1) 519.740.4100, Fax: (1) 519.623.8930Online: www.ab.com/mvb

3. Place the looped section of the ethernet patchcord over one side of the Ferrite Bead.

The looped cord must be against the inside surface of the Ferrite Bead.

4. Lengthen the crossed section so each side of the loop spans the complete length of the Ferrite Bead.

Figure 3 - Looped patchcord in the Ferrite Bead

5. Close the Ferrite bead securely and plug the patchcord into the ethernet switch.

Figure 4 - Closed Ferrite Bead