4Air vent screw
8Filter base
9Filter housing
12Oil drain valve
3Top nut
7Filter insert
14Valve on oil outlet
15Filter cover
2Pressure gauge
CJCTM Fine Filter HDU 15/25
PF1201 - 14.10.2013
8
2
9
3 4
11
5
12
6 7
1
Stop filter
Unscrew spring nut
Tighten spring nut until spring guide is level with top edge of filter housing.
Tightening torque minimum 4 Nm / 3 ft lbf
Replace O-ring and mount filter cover
Close valve on oil inlet
Remove spring and spring guide
Close valve on oil outlet
Remove used filter insert
Open air vent screw
Ensure filter base is clean
Open oil drain valve and drain waste oil
into container
Install new filter Insert
Unscrew top nut
Replace usit ring for top nut. Tighten top nut with torque of 70 Nm / 50 ft lbf
Mount spring guide carefully - make sure there is no contact between O-ring and thread
Lift off filter cover
13 14
4
12
3
5
67 8 7 6
Replace O-ring
15
Replace usit ring for air vent screw and
tighten with torque of 10 Nm / 7 ft lbf
FIlTeR InseRT RePlACeMenT
Filter Insert Replacement
7Filter insert
5
16
15
Replace O-ring
Valve on oil inlet
1Power On/OFF
10Pump
11Motor
13
5spring nut
6spring guide
4
Replace usit ring
17
Replace usit ring
3
18
Keep filter insert in plastic bag until use
Tighten spring nut
14
5
All disposal according to environmental regulation!
70 nm /50 ft lbf 10 nm /
7 ft lbf
15
13
Manufacturer: C.C.JENSEN A/S • Løvholmen 13 • DK-5700 Svendborg • Phone +45 6321 2014 • Fax +45 6222 4615 • [email protected] • www.cjc.dk
10
1