The delayed TR-NEWS allows to use the single focusing as a basis of amplitude modulation, to
create arbitrary wave envelope shapes in the focusing region. This could be used to introduce a
low-frequency component into the material by using high-frequency transmitter.
It was found that the reduction of the sidelobes in CFRP is still possible and effective by using
delayed TR-NEWS directly on the sidelobes: using a larger delay and smaller amplitude waves
tailored to directly arrive at the focusing point at the same time and magnitude as sidelobes
but in an opposite phase.
The future work in this subject will include the analysis of a local nonlinearity in the focusing
region using the proposed delayed TR-NEWS signal processing method. The FEM model can be
used to predict the probable size of a defect that could be detected with this method.
Abstract
Carbon Fibre Reinforced Polymer material with a contact gap defect is simulated by finite element method. The 2D simulation is based on a
simple laminate model of the anisotropic material layers. It is conducted in a 2D quarter space of simulated material with Lysmer and
Kuhlemeyer absorbing boundary conditions. The contact gap is included in the epoxy layer near the receiving transducer. It is modelled using
node-to-node contact algorithm. The Kuhn-Tucker normal contact conditions are satisfied by penalty plus Lagrangian multiplier method. Friction
effects are included using penalty method. The finite element dynamic wave propagation problem is solved explicitly by central difference
scheme using diagonalized mass and damping matrices. The simulation results are to be used to compare various non-destructive testing
methods meant for nonlinear defect detection, such as delayed Time Reversal - Nonlinear Elastic Wave Spectroscopy (TR-NEWS) and Pulse
Inversion. Using the simulation results, the interaction of the wave field with the defect inside the material can be closely examined to
investigate the benefits of advanced non-destructive testing methods.
Finite element simulation and delayed TR-NEWS analysis
of contact gap in carbon fibre composite Martin Lints1,2, Serge Dos Santos1and Andrus Salupere2
1 INSA Centre Val de Loire, Inserm U930 "Imagerie et Cerveau" , 3 rue de la Chocolaterie, CS23410, 41034 Blois France,
2Institute of Cybernetics at Tallinn University of Technology, Akadeemia tee 21, 12618 Tallinn, Estonia
[email protected], [email protected], [email protected]
Original TR-NEWS signal processing can be used to focus the wave energy under
the receiving transducer or vibrometer of an ultrasonic Non-Destructive Testing
(NDT) setup. It is a promising method for evaluation of complex, dispersive and
nonlinear media because it relies on the internal reflections for the focusing
process of the wave energy into a specific spot in a certain time, therefore taking
advantage of the complex internal structure of the material. Such focused wave
has an improved signal-to-noise ratio, making it suitable for investigating
dispersive, chaotic or highly attenuating media. The investigation has been
carried out initially experimentally on bi-layered aluminium block, then on a CFRP
sample. The findings are studied further using Finite Element Method (FEM)
simulation of wave motion in a stochastic layer thickness laminate model of CFRP
block to examine the signal propagation and focusing inside the material.
TR - NEWS = Time Reversal - Nonlinear Elastic Wave Spectroscopy [1]
Nonlinear Time Reversal methods
http://physics.aps.org/synopsis-for/10.1103/PhysRevLett.110.063902
Optimized excitation based on TR-NEWS approach for extraction of the
localized nonlinear signature in a complex chaotic medium : applied for
cryptography applications [5] (left) and applied for Non Destructive Testing
( NDT) applications (right) [4]
Fig 3: Experimental set-up
The physical interpretation of the cross-correlation function
Introduction
Conclusion
References
This work is supported by the Région Centre-Val de Loire (France) under the PLET project. This research has been conducted within the co-tutelle
Ph.D. studies of Martin Lints, between the Institute of Cybernetics at Tallinn University of Technology in Estonia and the Institut National des
Sciences Appliquées Centre Val de Loire at Blois, France. The laboratory visits have been funded by European Social Funds via Estonian Ministry of
Education and Research and Archimedes Foundation (30.1-9.3/287, 30.1-9.3/1137 and 16-3.4/1390) through DoRa and Kristjan Jaak Scholarship
programmes. This research is partly supported by Estonian Research Council (project IUT33-24)
Aknowledgments
1. Koen Van Den Abeele and Serge Dos Santos, Détection et localisation de microdégradation de マatéヴiaux paヴ spectヴoscopie d’oミdes élastiケues ミoミ linéaires, 2006 , pp 18-28 http://www.bruit.fr/flipbook/AT45/files/assets/basic-html/page26.html
2. M. Lints, S. Dos Santos, A. Salupere, Solitary waves for Non-Destructive Testing applications: Delayed Nonlinear Time Reversal signal processing optimization, Wave Motion, Volume 71, pp. 101–112(2017) http://dx.doi.org/10.1016/j.wavemoti.2016.07.001
3. Matthew Frazier et al, Nonlinear Time Reversal in a Wave Chaotic System, Phys. Rev. Lett., 110, 063902 (2013)
Scan this QR Code
for the poster ! !
Chirp-coded TR-NEWS Delayed TR-NEWS
Delayed TR-NEWS
Scan this QR code for the video
Scan these QR codes for the video
Samples
TR-NEWS focusing on the specific spot
Mor
e in
fo a
bout
this
art
icle
: ht
tp://
ww
w.n
dt.n
et/?
id=
2151
8