of 21
8/18/2019 Fits and Clearances.pptm
1/21
FITS AND
CLEARANCES
Eva Novitalia
Modul 7 – Kamis,11 februari2016
8/18/2019 Fits and Clearances.pptm
2/21
Today....•
Drill sizes for bolt oles, !lasses of "ts• !ommo# system of "ts a#d
$leara#$es
•%$edule of "ts a#d $leara#$es forair$raft a#d e#&i#es
• 'imits for bo( , t(ist a#d (ear
•%ta#dard metods for $e$)i#&safts, beari#&s a#d oter *arts
8/18/2019 Fits and Clearances.pptm
3/21
%ystem of "tsShaftNominal Size
Tolerance
Reference LineDimension
Upper and Lower LimitsActual Size
8/18/2019 Fits and Clearances.pptm
4/21
Trilo&y of+its
!leara#$e Tra#sitio#
8/18/2019 Fits and Clearances.pptm
5/21
8/18/2019 Fits and Clearances.pptm
6/21
8/18/2019 Fits and Clearances.pptm
7/21
FITSFITS ALICATI!NS
8/18/2019 Fits and Clearances.pptm
8/21
8/18/2019 Fits and Clearances.pptm
9/21
!ommo# system of "ts a#d$leara#$es
8/18/2019 Fits and Clearances.pptm
10/21
Ty*e of "ts
• -'E /%ED%%TEM
%ize of ole is )e*t$o#sta#t, saft size
is varied to &etdi3ere#t "ts.
• %-+T /%ED%%TEM
%ize of saft is )e*t$o#sta#t, ole sizeis varied to &etdi3ere#t "ts.
8/18/2019 Fits and Clearances.pptm
11/21
%imilarity
8/18/2019 Fits and Clearances.pptm
12/21
Tolera#$e
8/18/2019 Fits and Clearances.pptm
13/21
Tolerance onComponents
8/18/2019 Fits and Clearances.pptm
14/21
8/18/2019 Fits and Clearances.pptm
15/21
8/18/2019 Fits and Clearances.pptm
16/21
LI"ITS#STE"
8/18/2019 Fits and Clearances.pptm
17/21
/o( 'imit T(ist limit4ear 'imit
8/18/2019 Fits and Clearances.pptm
18/21
%ta#dard metods for$e$)i#& safts, beari#&s a#doter *arts• Dial Test #di$ator• !e$)i#& Metod
8/18/2019 Fits and Clearances.pptm
19/21
May as)
you....• -o( to de$ide tolera#$e5• 4y do you #eed "t a#d
$leara#$e5
• 4at te ris) of (ro#&"ts a#d $leara#$ei#stalled5
8/18/2019 Fits and Clearances.pptm
20/21
$UESTI!NS%
8/18/2019 Fits and Clearances.pptm
21/21
ASSI&N"ENT