3
Flange Facing Dimensions EN 1092-1 Tel: +86-23-67518067 Fax: +86-23-67955123 Hisea Industrial Group Co., Ltd http://www.chinahisea.com/flanges/
Flange Facing Dimensions EN 1092-1
Tel: +86-23-67518067 Fax: +86-23-67955123Hisea Industrial Group Co., Ltd http://www.chinahisea.com/flanges/
EN 1092-1 PN40 Flanges
Flange type (typ) as in EN 1092-1
01 (Plate [slip-on] flanges for welding) 13 (Hubbed threaded flanges)
02 (Loose plate flanges with weld-on plate collar) 21 (Integral flanges)
04 (Loose plate flanges with weld-neck collar) 32 (Weld-on plate collars)
05 (Blank [blind] flanges) 33 (Lapped pipe ends)
11 (Weld-neck flanges) 34 (Weld-neck collars)
12 (Hubbed slip-on flanges for welding)
Tel: +86-23-67518067 Fax: +86-23-67955123Hisea Industrial Group Co., Ltd http://www.chinahisea.com/flanges/
EN 1092-1 PN40 Flanges
Note 1: Dimensions N1, N2 and N3 are measured at the intersection of the hub draft angle and the back face of the flange. Note 2: For d1 dimensions see document "Flange Facing Dimensions EN 1092-1".
Tel: +86-23-67518067 Fax: +86-23-67955123Hisea Industrial Group Co., Ltd http://www.chinahisea.com/flanges/
![OPTIFLUX 5000 · 1" 1 1/2" 2" 3" 4" DIN [mm] 2,5 4 6 10 15 25 40 50 80 100 Nominal flange pressure EN 1092-1 - PN40 EN 1092-1 - PN25 EN 1092-1 - PN16 ASME B16.5 - 150lbs ASME B16.5](https://static.documents.pub/doc/80x56/605edffa640a9a548b7da7d2/optiflux-1-1-12-2-3-4-din-mm-25-4-6-10-15-25-40.jpg)
![FF-120, Pipe Flange Face Tool - Buffalo Hydraulic...with flange OD facing range 25,4 - 304,8 mm [1 - 12 inch] • Interchangeable collets for ID mounting range 25,4 - 152,4 mm [1-6](https://static.documents.pub/doc/80x56/5f1eb9b9fc4524361f37bcca/ff-120-pipe-flange-face-tool-buffalo-hydraulic-with-flange-od-facing-range.jpg)
