For wire harness manufacturers

The cutting specifications can be automatically downloaded from the production data files (downloadable via

company network, flash drive, etc.).

A rework mode (manual input) is also included in the software for smaller volume production.

EasyCut software and the various proposed options (traceability, label printing, etc.) are fully compatible with

the ULYS Modena and MRO200 range of products.

MRO CUT can be easily upgraded into a MRO200 laser wire marker later on.

Machine requirements:

208V / 240V single phased current 16 Amps

6 bars (90 PSI) compressed air

Cable tension control

Operating temperature:

+15°C to +32°C (60°F-90°F)

Storage temperature:

+1°C to +45°C (34°F-113°F)

Maximum humidity: 80%

Multilingual software

EASY TO INSTALL with little restriction on location

Excellent MOBILITY thanks to four lockable wheels

USER-FRIENDLY DESIGN

HIGH PRODUCTIVITY of up to 60m per minute

MINIMAL USER INTERVENTION

Compatible with MANY TYPES OF CABLES (from gauges

6 to 26, twisted, jacketed and non-jacketed, etc.)

AUTOMATIC SORTING OF DATA according to production

modes

AUTOMATIC CUTTING with protection tape, notably for

twisted cables, to prevent fraying

AUTOMATIC HALT TO PRODUCTION in case of cable

blockage, opening of safety hood or any other fault

MOTORISED coiling pan

Conforms to AERONAUTICAL INDUSTRY STANDARDS with

regards to the cutting of 26 AWG wires to 6 AWG wires

Conforms to EC Directives on “working equipment” and

to EC STANDARDS

Coiling pan available in various diameters

High-definition label printer

Traceability with bar code reader

Automatic detection of faults by optical sensor

(knots, cut cables, etc.)

EasyHelp telemaintenance kit

Non-contractual photos.

Above specifications are subject to change without notice.

UV laser wire & cable identification systems

to MRO200-B / S / XS