Date post: | 09-Jun-2015 |
Category: |
Documents |
Upload: | siriusintegrator |
View: | 225 times |
Download: | 0 times |
Sirius Integrator
North American Distributor
APPLICATIONSLeisure
BoatingCaravans/Recreational Vehicles
CommercialTraffic management/data loggingBus shelter signageRemote station utility
ScientificAntarctic Survey (UK, Germany, Japan,
USA, Australia), remote weather stations
Scientific – Antarctic Survey
Scientific – Transport
Scientific – Navigational Buoy
Leisure – Boating and Caravans
Commercial Leisure..
Products include:Forgen 500 series & Forgen 1000 seriesTwo versions with each series
NT version – Normal Temperature LT version – Low Temperature
Various Mounting Options include:Wedge Mount and Bracket – used to fit to a
vertical flat surfaceRail Plate c/w wedge mount and bracket – used
to fit to a tubular vertical or horizontal railSide Mount – used in extreme environments of
cold temperature and high windsPole Mount – Mounting on top of a standard
2”/50mm pole
Wedge Mount and Bracket
1. The wedge is fitted to a flat surface via 3 countersunk screws.
2. The bracket is then slotted over the wedge to provide a tight, secure fit.
3. Tighten the grub screw at the base of the bracket
BRACKET AND WEDGE
Rail Plate c/w Wedge Mount
1. The wedge is fitted to the pre drilled rail plate.2. The rail plate is then fitted to a horizontal or
vertical tube/rail.3. The bracket is then slotted over the wedge in the
same way as the standard wedge and bracket configuration.
Note: This configuration is often used to fit a turbine to a guard rail on a boats transom.
Side MountThis mounting arrangement is fully assembled at the factory, such that installation is carried out by simply fixing the vertical bar to a horizontal surface (usually via countersunk screws)
Note:This mounting is most suitable for extreme environments including consistently high winds.
Pole Mounting1. The Forgen wind turbine is fist located
and fixed to the top of the mount via a threaded hole and nuts.
2. There is the option of pulling the cable through the centre of the pole using the external gland located on the side of the pole mount.
3. Tighten the pole mount to the pole using the three grub screws located on the bottom of the pole mount as shown.
Threaded hole
External gland
Grub screws
A small sample of end users…
Thank You
Sirius Integrator, Inc.100 Jackson Road, Devens MA 01434 FED ID: 26-4255096Duns Number: 831627729CAGE Code: 5NQD4 Phone/Fax: 855-747-4874 (855-SIRIUSI) www.siriusintegrator.comwww.alwaysoffgrid.com (soon to launch marketplace)