G

G--

-0

4/1

3--

-A

dd

ed m

oto

r o

ver-

tem

per

atu

re (

UL

com

plia

nce

) la

ngu

age

to P

age

3-1

3

3INSTALLATION

INTRODUCTION

This chapter contains the information and procedures required to complete the initial installation and wiring for the M-Drive. All pages within this chapter must be read to ensure that the appropriate decisions are made prior to the final wiring of the M-Drive.

Note to Electricians installing the M-Drive:

- Class G branch circuit fuses rated 250V, 15A shall be provided in the end application.

- Motor overload protection shall be provided in the end installation in accordance with the NEC.

- This drive does not provide over-temperature sensing.

The installation of this motor control must conform to area and local electrical codes. For information, refer to the National Electrical Code (NEC) Article 430 published by the National Fire Protection Association, or the Canadian Electrical Code (CEC). Refer to local codes as applicable.

Hazardous voltages are present during certain installation procedures. Therefore, the M-Drive should only be installed by qualified electrical maintenance personnel.

WARNING

This chapter is organized into 2 distinct sections:

MOUNTING

WIRING

The Mounting section provides drawings and instructions for mounting the M-Drive in an enclosure. The Wiring section summarizes the wiring connections for the M-Drive.

Page 3-1