GEN IV IP NVR Setup And Instructions

Playback Recordings1) Click and select your device 2) Select Camera in next box a) To select more then one camera check “Multiple Channel b) Select Camera in drop down box and click “Add” for each camera you want to playback3) Select your date, start time, and end time4) Click on Search5) Select your time range in the results window6) Click Play

Save to Hard Drive

1) Click and select your device2) Select Camera in next box a) To select more then one camera check “Multiple Channel b) Select Camera in drop down box and click “Add” for each camera you want to playback3) Select your date, start time, and end time4) Click on Search5) Select your time range in the results window6) Click “To AVI”7) This could take a while depending on the amount of time selected.

Burn to CD1) Follow directions in “ Playback to Hard Drive “2) Locate file and copy it to CD burner3) Click burn

Local Setup For PSS Software

When Screen options are out of line or do not show up at all

You may need to go into your screen resolution

Click here to change textsize. In the next windowClick 100% and click Apply/OK.

1)Press full Menu Icon on the top left of screen.

2) Select “Device”3) Select “Device Manage”

4) Press “Search Device” The NVR info will appear on the top line

5) Check the box to the left of the NVR info

6) Press “Add Management”

7) Enter “admin” for the user and “admin” for the password

8) Click OK

9) Click OK

Remote Setup For PSS Software

When Screen options are out of line or do not show up at all

You may need to go into your screen resolution

Click here to change textsize. In the next windowClick 100% and click Apply/OK.

1)Press full Menu Icon on the top left of screen.

2) Select “Device”3) Select “Device Manage”

4) Click on “Manual Add”

5) Enter name of location

6) Change type to NVR

7) Enter your WAN IP ( office IP )From your computer go to Whatismyip.com to get this info.

8) Enter User name and passwordUser Name and PasswordAre both admin

9) Click Add

10 ) Click OK

View Cameras LocallyOr Remotely

1) Click on Device List

2) Click on No group

3) If there is a “X” over IP address right click and then click logon. If there is No “X” then click on “+” toOpen all connected cameras.

4) Click on viewing window. When clicked onThere will be a green box around it.

5) Double click on CameraYou wish to appear in thewindow

6) The highlight willAutomatically switch to Next box. Double click On the next camera you Want to view.

To Save Monitor Settings

Camera’s will come back up as last viewed when the PSS software is reopened

1) Click on config2) Click on Options

3) Click the check box for “ Save

Last Monitor Status “