(Unless otherwise listed, all coatings were allowed a minimum 30-day cure prior to testing.)
Test Method Glassprimer™
ASTM D 3359 Tape Test
ASTM D 3363Pencil Hardness
4H
ASTM D 2794Impact ResistanceDirect/Indirect
48/4
ASTM D 522Method A Conical Mandrel Bend
½” Crack
ASTM D 2369VOC Method 24
2.32 lbs.
ASTM D 3278Flash Point (mixed)
93°F
ASTM STP 500 Pass 1900g weightHoffman Scratch
5B
ASTM D 870Water Immersion
65° C-40 DaysPass
Pass
ASTM C 1503-1Salt Spray
600 Hours
Pass
ASTM C 373Boiling Water
5 Hours
Glassprimer™ Products
Test Results Glassprimer™ GPPP083/GPUC083Page 1 of 2
GPPP083/GPUC083
System
System
(Mils)
ASTM D 714 ASTM D 1654 Total Blistering Undercutting DFT
Blistering DFT
Glassprimer™ ProductsTest Results Glassprimer™ GPPP083/GPUC083 Page 2 of 2
None10
0.1 De
Degree of Chalking ASTM D 4214
8 h UV/45°C2,000 hours exposureASTM D 4587 QUV-A bulbs
GPPP083/GPUC083
GPPP083/GPUC083
ASTM D 714 Total
4 hr CON/40°C
Color Change
Glassprimer™ 10-None 8.1
Glassprimer™ 6M/6M 10-None 7.4
Planar/Scribe At Scribe (Mils)
GPPP083/GPUC083
System
(Unless otherwise listed, all coatings were allowed a minimum 30-day cure prior to testing.)
(Unless otherwise listed, all coatings were allowed a minimum 30-day cure prior to testing.)
(Unless otherwise listed, all coatings were allowed a minimum 30-day cure prior to testing.)ASTM D 4585 Cleveland Humidity Testing, 2000 hours
ASTM B-117 Salt Fog Testing, 2000 hours
Glassprimer™ Pass Pass
Adhesive Compatibility Testing, 5 years
Palmer Mirro Mastic Silicone Adhesive
Glassprimer™ Products01/22/1999
Alkoxy Neutral Cure