Date post: | 20-Aug-2015 |
Category: |
Technology |
Upload: | ali-osman-oencel |
View: | 3,410 times |
Download: | 1 times |
Department of Earth SciencesKFUPM
Gravity Modeling 3
Introduction to GeophysicsIn
trod
uct
ion t
o G
eop
hysi
cs-K
FUPM
Highest peaks on the planet
Quiz of the Week
What does a positive Bouguer anomaly indicate? How about a negative Bouguer anomaly?
10 minutes
Intr
od
uct
ion t
o G
eop
hysi
cs-K
FUPM
Previous Lecture
Regional Gravity due to dipping plane Sources of the Local and Regional Gravity Anomalies Wavelength Changes of Anomaly regarding the burial depth of material Factors effecting the Gravity Anomalies
Density Contrast Depth to anomaly Source Geometry
Gravity Effect of Sphere Depth Estimates
Intr
od
uct
ion t
o G
eop
hysi
cs-K
FUPM
Gravity stations in Saudi Arabia508397 points
Saudi Geological SurveyIntr
od
uct
ion t
o G
eop
hysi
cs-K
FUPM
Bouguer gravityDensity 2.3 gm cm-3
Bouguer Anomaly Map of Saudi Arabia
Saudi Geological Survey
Intr
od
uct
ion t
o G
eop
hysi
cs-K
FUPM
Half Width Depth Estimates
• The depth to the top of a gravity source can be determined approximately from half-width x½ of anomaly x½ is half distance from the centre of anomaly at which amplitude has decreased to half its peak value Z is depth for spherical object z = 1.305x½
z = 1.305x½
Intr
od
uct
ion t
o G
eop
hysi
cs-K
FUPM
Other Objects
Effects of various bodies can be written by inserting term for object volume and density contrast into gravity equation
Intr
od
uct
ion t
o G
eop
hysi
cs-K
FUPM
Gradient-Amplitude Method
• Z is depth which also can be estimated to source based on the gradient of the anomaly side slopes •depth found from ratio of maximum amplitude to
gradient z < 0.86 Δg max / Δ g‘ max
Intr
od
uct
ion t
o G
eop
hysi
cs-K
FUPM
Ambiguity in Gravity Interpretation
Gravity interpretations are ‘non-unique’• infinite number of combinations of object geometry, depth and density contrast can yield the same anomaly
There are two approached to the interpretation of Bouguer anomaly data. One is direct where the original data are analysed to produce an interpretation. The other is indirect, where models are constructed to
Intr
od
uct
ion t
o G
eop
hysi
cs-K
FUPM
An infinite slab adds or subtracts a constant amount to the gravity field, depending on whether the slab represent a positive (+Δm) or negative (-Δm) mass anomaly.
Gravity variation due to Infinite Slab
+Δm = +Δgz
-Δm = -Δgz
Intr
od
uct
ion t
o G
eop
hysi
cs-K
FUPM
1. No significant gravity effect in regions far from the slab;
Gravity variation due to semi-infinite Slab
3. The full (positive or negative) gravity effect in regions over the slab but far from the edge
The gravity effect of a semi-infinite slab changes gradually as the edge of the slab is crossed as in the following:
2. An increase or decrease in gravity crossing the edge of the slab;
Intr
od
uct
ion t
o G
eop
hysi
cs-K
FUPM
An infinite slab produces exactly the same gravity as the slab used for the Bouguer correction as:
Δgz =0.0419ΔρΔh
Estimating Δgz for an infinite slab
Intr
od
uct
ion t
o G
eop
hysi
cs-K
FUPM
1. The gravity effect of a semi-infinite slab is equal to the Bouguer slab approximation far out over the slab (right),
Estimating Δgz for an infinite slabGravity effect of a semi-infinite slab changes
according to position relative to the slab’s edge.
2. ½ of that value directly over the slab’s edge, and zero far away from the edge (left). In
trod
uct
ion t
o G
eop
hysi
cs-K
FUPM
The angle Ф can be expressed: Ф = π/2 + tan -1 (x/z)
Ф=90 (Away from the slab) Ф > π/2 (Over the slab)
Griffiths and King (1981) develop an equation for the anomaly caused by a semi-infinite slab:
Δgz= G (Δρ) (Δh) (2Ф)
Ф= angle (in radians) from the observation point, between the horizontal surface and a line drawn to the central plane at the slab’s edge
Gravity for Semi-Infinite Slab
G=Universal Gravitational Constant (6.67x10-11 Nm2/kg2).
Intr
od
uct
ion t
o G
eop
hysi
cs-K
FUPM
Gravity for Semi-Infinite Slab
1. X=- ∞ Δgz=zero Δgz=0 (41.9 Δρ Δh)
2. X=- z Δgz=¼ its full value Δgz=¼ (41.9 Δρ Δh)
3. X= 0 Δgz=½ its full value Δgz=½ (41.9 Δρ Δh)
4. X=+ z Δgz=¾ its full value Δgz=¾ (41.9 Δρ Δh)
5. X=+ ∞ Δgz=its full value Δgz=1 (41.9 Δρ Δh)
Δgz= 13.34 (Δρ) (Δh) (π/2 + tan-1 [x/z]
Units are:Δgz in g/cm3 Δρ in g/cm3 Δh, x, z in km
Intr
od
uct
ion t
o G
eop
hysi
cs-K
FUPM