GS3055-IGSM Universal Wireless

Alarm Communicator

CONFIDENTIAL

GS3055-I Overview

The GS3055-I is:

1. A GSM universal wireless alarm communicator that can be used in a backup or primary role.

2. A device that connects the alarm control panel to the GSM network and reports alarm signals directly to a monitoring station receiver (Sur-Gard System II/ System III).

3. A digital transmitter that provides full reporting from any control panel that communicates using Contact ID format.

CONFIDENTIAL

GS3055-I GSM Network Terms

Network Terms:

GSM – (Global System for Mobile Communication) – Digital Wireless Network for Voice and Data

GPRS – (General Packet Radio Service) – GSM data channel, continuous connection up to 100Kbs

SMS – (Short Message Service) – Text-based messages no longer than 160 alphanumeric characters

APN – (Access Point Name) – GSM provider’s gateway

SIM – (Subscriber Identification Module) – Stores information used to identify users in a network

CONFIDENTIAL

GS3055-I Features

Features:

• Compatible with any control panel that communicates using the Contact ID format

• Simulates Phone line , therefore communicating all of the control panel events

• Uses GPRS data channel for high-speed, reliable, and low cost communications to an IP receiver

• 4 on-board inputs

• 4 on-board outputs (open collector)

• SIM card is included

• Activation and initialization via the automated telephone system (GVRU)

• Programmable via web interface

• Compatible with Sur-Gard System II/System III monitoring station receivers (Either may be used as Primary and/or Backup)

• UL/ULC Residential Fire/Burg and Commercial Burg only (UL985, UL1023, and UL1610) - For either primary or backup communications

CONFIDENTIAL

GS3055-I Communications Flow Chart

CONFIDENTIAL

GS3055-I Specifications

Specifications:

Power Supply RatingsInput Voltage 9 -14Vdc (13.5Vdc Typical)Current 120mA (JP3 OFF) or 700mA (JP3 ON)Battery 12V/1.2Ah

Charging current 50mA

Current ConsumptionStandby Current 120mATransmitting Current 450mAPGM Outputs 4 Open Collector, 50mA

Operating Frequency 850/1900MhzAntenna Gain 1.5dBOperating Temperature 0ºC to 49ºC (32ºF to 120ºF)Internal Event Buffer 256 Events

CONFIDENTIAL

GS3055-I Components

Components:

1. Antenna2. SIM Card3. LED Status Indicator4. GSM Modem5. Terminal Blocks6. Battery Connector7. Front Plate Tamper Switch8. JP3 Current Limitation Jumper

CONFIDENTIAL

GS3055-I Components

Components:

1. Antenna2. SIM Card3. LED Status Indicator4. GSM Modem5. Terminal Blocks6. Battery Connector7. Front Plate Tamper Switch8. JP3 Current Limitation Jumper

CONFIDENTIAL

GS3055-I Components

Components:

1. Antenna2. SIM Card3. LED Status Indicator4. GSM Modem5. Terminal Blocks6. Battery Connector7. Front Plate Tamper Switch8. JP3 Current Limitation Jumper

CONFIDENTIAL

GS3055-I Components

Components:

1. Antenna2. SIM Card3. LED Status Indicator4. GSM Modem5. Terminal Blocks6. Battery Connector7. Front Plate Tamper Switch8. JP3 Current Limitation Jumper

CONFIDENTIAL

GS3055-I Components

Components:

1. Antenna2. SIM Card3. LED Status Indicator4. GSM Modem5. Terminal Blocks6. Battery Connector7. Front Plate Tamper Switch8. JP3 Current Limitation Jumper

CONFIDENTIAL

GS3055-I Components

Components:

1. Antenna2. SIM Card3. LED Status Indicator4. GSM Modem5. Terminal Blocks6. Battery Connector7. Front Plate Tamper Switch8. JP3 Current Limitation Jumper

CONFIDENTIAL

GS3055-I Components

Components:

1. Antenna2. SIM Card3. LED Status Indicator4. GSM Modem5. Terminal Blocks6. Battery Connector7. Front Plate Tamper Switch8. JP3 Current Limitation Jumper

CONFIDENTIAL

GS3055-I Components

Components:

1. Antenna2. SIM Card3. LED Status Indicator4. GSM Modem5. Terminal Blocks6. Battery Connector7. Front Plate Tamper Switch8. JP3 Current Limitation Jumper

CONFIDENTIAL

GS3055-I Components

Components:

1. Antenna2. SIM Card3. LED Status Indicator4. GSM Modem5. Terminal Blocks6. Battery Connector7. Front Plate Tamper Switch8. JP3 Current Limitation Jumper

CONFIDENTIAL

GS3055-I Status LEDs

LED 1(RED)

OFF – No Troubles1 Flash – Battery Trouble (No or Low Battery)2 Flashes – Radio/SIM Failure (Check SIM Card Connection)3 Flashes – GSM Network Problem (SIM Not Active, Low SS)4 Flashes – Insufficient Signal Strength5 Flashes – CONNECT 24 Configuration SMS Failure (Improper VRU Programming)6 Flashes – Receiver Not Available (Improper VRU Programming)7 Flashes – Power Supply Trouble (DC Power Supply Absent)

LED 2(AMBER)

ON: GSM Mode Active (Telephone Line is Disconnected)Flashing: Once – Outgoing Message; Twice – Incoming Message

LED 3(GREEN)

ON: Excellent Signal Strength

LED 4 (GREEN)

ON: Good Signal StrengthFlashing: Poor Signal StrengthOFF: GSM Network is Unavailable

CONFIDENTIAL

GS3055-I – Terminals

Earth Ground: This terminal must be connected to the GS3055-I metal casing.

CONFIDENTIAL

GS3055-I – Terminals

TIP, RING: These terminals must be connected directly to the incoming telephone line.

T1, R1: These terminals must be connected to the TIP and RING of the control panel.

If the voltage on the phone line terminals (TIP, RING) drops between 10 – 15 seconds to less than 4Vdc, the GS3055-I will switch into GSM mode for 15 minutes. At this time T1 and R1 will simulate dial tone (34.5Vdc)

CONFIDENTIAL

GS3055-I – Terminals

PGM1 to PGM4: These are 4 programmable output terminals (open-collector, maximum current of 50mA).

PGM1 – normally high and will switch to ground when the telephone line is down.

PGM2 – normally high and will switch to ground when the GS3055-I cannot communicate to GSM network.

PGM3 – normally high and will switch to ground when there is a problem with the PS or battery.

PGM4 – normally low and will switch to high when any of the above occurs and/or on FTC condition

CONFIDENTIAL

GS3055-I – Terminals

TAMPER: These terminals are connected in series to the tamper switch of the GS3055-I. They will be closed when the cabinet is properly closed, and will open when the front cover is removed.

CONFIDENTIAL

GS3055-I – Terminals

Z1 to Z4, COM: These are input terminals that can be used to trigger various communication events on the GS3055-I. The inputs are normally open. No EOL required.

Input 1 = Fire

Input 2 = Panic

Input 3 = Burglary

Input 4 = System Trouble

CONFIDENTIAL

GS3055-I – Terminals

+12V, -12V: These terminals must be connected to a rated power supply.

CONFIDENTIAL

GS3055-I – Telephone Wiring (Back-up Mode)

To Premise Telephones

From RJ-31X Demarcation

CONFIDENTIAL

GS3055-I – Telephone Wiring (Primary Mode)

CONFIDENTIAL

GS3055-I Central Station Equipment

System II/ System III Receiver:

A System II receiver supports 1024 IP Communicators A System III receiver with 1 DRL3-IP line card supports 1024 IP

Communicators A System III has a maximum of 24 line cards; 24,576 IP

Communicators Compatible IP Communicators are: TL150, TL250, TL300 and

GS3055-I units

CONFIDENTIAL

GS3055-I

Questions?