Sun Awning Poles System Featuring high-tech carbon fiber construction and fantastic matt finishing, Exit Carbon’s sun awning poles come in a variety of lengths and diameters to perfectly match your stern or bow deck. Designed for use on motor and sailing yachts, these poles are extremely light-weight, easy to set up, and stow anywhere with wall clips. TECHNICAL DATA Length 150, 175, 200 cm Diameter 32, 38 mm Angle 0° or 6° Connection ring or Clamcleat®
Transcript
Sun Awning Poles System
Featuring high-tech carbon fiber construction and fantastic matt finishing, Exit Carbon’s sun awning poles come in a variety of lengths and diameters to perfectly match your stern or bow deck.
Designed for use on motor and sailing yachts, these poles are extremely light-weight, easy to set up, and stow anywhere with wall clips.
HELIOS is a carbon sun awning system specially designed for small to medium boats. It consists in carbon fiber poles and a set of female deck sockets.The number of poles might typically be 2 to 4 per yacht, but the choice is up to you.
STRONG, AFFORDABLE & AESTHETICALLY PLEASINGCarbon fiber strength makes these poles stable support for your sun awning. No vibrations means a quieter boating experience at anchor, but also during slow navigation. Their simple and affordable elegance adds value to any boat.
CUSTOMIZE YOUR SHADEThe carbon fiber poles come in Exit Carbon’s signature carbon look, or a custom color of your choice.
- Choose from three lengths (150 cm, 175 cm, or 200 cm), two diameters (32 mm or 38 mm), and two angles (0° or 6°).
- Choose the suitable socket for your own yacht. With angled sockets you can follow the lines of your boat superstructure or widen the cover at shoulder height, while keeping a small perimeter on deck.
- Select how to attach your awning rope: with a simple eye bolt on top (as shown in the top photo) or with a Clamcleat® on the side, for adjustable tension.
EASY TO SET-UP & STOWLight and simple to use, the poles can be quickly set up and just as quickly stowed against any bulkhead or wall with clips.
Simplify the fitting of the female deck sockets with this strong, stainless steel counter-flange with threaded holes.
Instead of using nuts with wide washers to be individually tightened, holding your key below deck, use this single counter-flange. It distributes the load better than the widest of washers, but most of all, once you fit the 3 screws into their threaded holes, you won’t need to use any key below deck when tightening the screws. Just tighten the screws from the top, alternating between them until done.
STORAGE CLIPS
Use our spring clips, made with stainless steel and rubber, to hang your Helios poles inside your locker.
The long, thin shape, coupled with the light weight of the carbon poles, enables them to stay close to a bulkhead or roof without taking useful space from the locker.
38 mm, 6° angle stainless steel female socket with drain tube (1) € 150
38 mm, stainless steel rear flange (threaded) (2) € 40
Storage clips € 30
CONFIGURATION
(1) All our sockets are supplied with highly polished outer flanges and polymer sleeves to avoid metal-on-carbon contact.
(2) The stainless steel rear flange is very convenient for easy assembly and optimal load distribution on an extended deck surface. The flange has 3 threaded holes that correspond with the top flange holes, so no nuts are needed.
