HermanMiller Assembly Instructions3
How to assembleyour Nelson Thin Edge Bed.
HermanMillerNelson Thin Edge Bed(King,Cal King)Installation Instructions
For more information about our products and services or to see a list of dealers, please visit us at
www.hermanmiller.com/product-instructions or call 888 - 443 - 4357.
© 2015 Herman Miller, Inc., Zeeland, Michigan Printed in U.S.A. Part No. 1BFXZ8 - C.
4mm AllenWrench (1)
Parts Included
Safety Instructions & Warning
• Read all instructions before using products
• Failure to fully tighten screws may cause injury
• Periodically check fasteners to ensure tightness
• The right is reserved to make changes at any time without notice
• Will require at least 2 people
Wood Bed Frame (LH) (1) Wood Bed Frame (RH) (1) Top Rail (2)
Short Bolt(46)
LargeSpanner Plate
SmallSpanner Plate
Medium Bolt(12)
Long Bolt(2)
Long Bolt
Barrel Nut(2)
Barrel Nut
Start with bed frames facing upward. Ensure frames are properly aligned.
Note: Will require at least 2 people.
Use 2 Long Bolts and Barrel Nuts to connect frames together to assemble the platform.Tighten with allen wrench.
Step 1 Step 2
Steel Leg(2)
Wood Leg(6)
Headboard (1)
OR
H-Legs (2)
HermanMiller Assembly Instructions4
Carefully flip connected frames over in orientation shown below ensuring both framesdo not bend relative to each other.
Step 3
Attach large spanner plate at foot end of bed with 6 Short Bolts.
Flip frame over so it is right side up being careful not to put weight on legswhile flipping.
Attach wooden top rails to both ends using 6 Medium Bolts each. Use top rail with nobranding plate on end with large spanner plate. Use top rail with branding plate on other end. Ensure branding plate is facing outward.
Step 4
Step 6
Step 7
Attach center and outer legs using 4 Short Bolts per leg.
Step 5
Wood Leg Option
Steel Leg Option
Short Bolt
Large Spanner Plate
Medium Bolt
Branding Plate
HermanMiller Assembly Instructions5
Attach outer headboard support plates to frame using 4 short bolts for each.
Step 8 Step 9
Branding Plate
Small Spanner Plate
Short Bolt
Attach inner headboard support plates and small spanner plate using 8 short bolts in total. The spanner plates sits on top of the headboard support plates as shown below.