2
HFA3 LED-Ready Specification Sheet Project: Catalog#: Approved by: Highbay LED-Ready Six Lamp Positions Four Foot - Curved Profile Design Lamps NOT Included Specifications subject to change without notice. Howard Lighting Products | 580 Eastview Drive | Laurel, MS 39443 (toll free) 800.956.3456 | (direct) 601.422.0033 | (fax) 601.422.1652 www.HowardLightingProducts.com Page 1 of 2 Rev: 1/29/2019 Features • No ballast installed • Includes shunted and non-shunted T8 lamp holder so they are compatible with single-ended and double-ended 4’ LED tubes (Type B) • Easy access to wiring compartment • Access plate provides access to electrical wiring with-out the need to open the fixture • Knock-outs for easy electrical wiring and assembly • Heavy Duty pre-painted steel construction • Can be easily mounted by a single person • Suspended mounting insures a quick painless install • Chain and V-Clip Hanging option • Standard specular aluminum reflector (86%) • Wire cable hanging option. Description The HFA3-LED Ready series high-bays are a great retrofit LED ready alternative to traditional HID highbay and fluorescent fixtures. This fixture uses 6 line voltage 4’ LED lamps (Type B). Applications Warehouse Gymnasium Manufacturing Facility Cafeteria Auditorium Benefits • Energy Saving Compared to HID systems • Quality Lamp holders • Computer Designed Reflectors Ordering Information Model No. of Lamp Positions** Reflector (L) Length (W) Width (H) Height HFA3A6LT8 6 Standard Specular Aluminum (86%) 48” 16.23” 3.6” Proudly Designed & Assembled IN THE USA* **Lamps Not Included *Foreign and domestic components. Pendant Mount lances included only if Factory Installed Option “J” is selected. 3.6” 16.23” 48” Rigid heavy gage prepainted steel body Contractor friendly one screw access to electrical connections through this access plate removable from the outside Hinged reflector/socket bar assembly for easy two screw access to the ballast compartment Factory Installed Option J Pendant Mount Kit (PMK2) installs from the outside: no need to open the fixture Wire Cable Hanging mounting option (WCH) Chain and V-Clip mounting option (CV) Six 3/4” knockouts for easy wiring access 4 on top and one on each end provides clean mounting for occupancy sensor Curved design for better light distribution Compatible with F32T8/8xx/LED/16W/AC & F32T8/8xxLED/12.5W/AC Linear LED Lamps click image for spec sheets LAMPS NOT INCLUDED
