1
HOLOBOPP HOLOBOPP Metal receptive layer Heat sealable layer High barrier metallized layer holographic microembossing OPP core 2F 2F HOLOBOPP SHIELD METALLIZED FILM 2F Technical Data(Typical values ) PROPERTIES 2F-17 UNIT METHOD MEASURING Nominal thickness 17 microns 68 Gauge Unit weight 15.9 g/m 2 3 ISO 4591 Density 0.91 g/cm Yield 62.9 m 2 /kg Heat-seal strength 1.8 N/15 mm HOLOMEX Optical density 2.4 Densitometer Tensile strength machine direction transverse direction machine direction tranverse direction 150 270 N/mm 2 DIN EN ISO 527-1/-3 N/mm 2 DIN EN ISO 527-1/-3 Water vapour permeabillity g/m 2 - day 38°C/90% RH 0.3 . +-10% ASTM F 1249 23°C/0-90% RH 30 DIN 53380-3 E longation at break: Oxygen transmission rates: cm /m - day-bar 160 % DIN EN ISO 527-1/-3 60 % DIN EN ISO 527-1/-3 TYPICAL STRUCTURE 3 2 is a high barrier metallized film designed for extrusion lamination. It is a biaxially oriented, co-extruded polypropylene film and it gives enhanced light and very high moisture and oxygen barrier. With its excellent metal adhesion it allows extrusion as well as adhesive lamination. Its heat sealable layer on the non-metallized face provides good heat seal integrity. Reels are normally wound with the metallized face on the outside, but can sometimes be supplied on request with the metallized face wound inside. PRODUCT FEATURES Physical Characteristics ■ High resistance to tear and puncture. ■ Excellent resistance to low temperatures. ■ Dimensionally stable under conditions of varying humidity. ■ High heat seal strength. Film Characteristics ■ Low water vapour permeability. ■ Water repellent. ■ Resistance to biological oil and biological grease. ■ Odourless and taste free. ■ Physiologically harmless, thus suitable for food packing. Special properties ■ High barrier properties. ■ Suitable for extrusión lamination APPLICATIONS AND PROCESSING ■ HOLOBOPP 2F can be used for packaging various types of products, for example products wich require higher than standard protection against moisture, odour or dehydration. Laminating ■ Adhesive or extrusion lamination with OPP or with other substrates, depending on application. Packaging ■ HOLOBOPP 2F is suitable for use on a variety of form, fill and seal machines. ■ Place HOLOBOPP 2F in the processing area approximately 24 hours prior to processing. Storage Food safety HOLOBOPP 2F has been developed specially for packaging foods and meets which includes the specific "German Food and Commodity Act" and the current recommendations of the BIR. Compliance with other specific national regulations is available on request. It is not recommended that the metallized surface is used in direct contact with food the specific requirements on health and safety. It meets the FDA and EC regulations, Hologramas de México S.A. de C.V. accept no responsibility for results obtained by the application of this information or the safety or suitability of our products, either alone or in combination with other products. Users are advised to make their own test to determine the safety and suitability of each product or product combination for their own purposes. HM-DPPR05-I EMISSION 05-SEP-07 USE 13-SEP-07 VERSION 00
