How to connect the power supply to test a car dvd player before installation？

• Once we receive an order from customer, we will check every car dvd player carefully before dispatch. Here, I will show you how to connect the power supply to test a car dvd player before installation. So you can test the device yourself before installation. Because the oversea delivery may more or less cause damage to the product, test the item before installation efficiently avoids trouble caused by installation and uninstall.

Here are the steps with detail pictures, I will take BMW E39 Car DVD player as an example.First, open the package, take a look at the back side of car dvd player.

Take out the power connection cable which is contains in package list, the following is ours, speci

alized for test machines.

Link it up with car dvd player.

Second, connect ACC cable with power line.

Link GNP line with GNP

Third, link radio connection cable and GPS line with car dvd player.

GPS signal line from your car.

The port of GPS is on the middle body of car dvd player.

So link them up.

The following is the finish shot of connection.

Turn on the power, you will see a big BMW logo, congratulations, the car dvd player is in decent condition, go on to check other function of the device.

• For GPS setup questions, Bluetooth setup questions, rear camera installation questions, SWC – Steering Wheel Control questions, please refer to www.autodvdnavigation.com

• If you have any further question, post your words afterwards, I will be glad to answer them.

• sales@autodvdnavigation.com