How to Install LED Flexible Strips ?Single Color Non-waterproff LED Strip

Step 1

If you look closely at the strip, there is a line that can be cut about every 2 inches. Between every two lines, there is a complete circuit.

Step 2

Then, you can go ahead and begin to cut the strip. Use a pair of scissors to cut the LED strip along with the line. You can have the strip as small as 2 inches, or as long as 16.4 feet.

Step 3 (How to connect two LED strips)

Kindly use connector to connect two LED strips together. Make sure you connect the positive signs of the two strips together, and the negative signs together.

Step 4

Use a connector with the DC plug to connect the LED strip to the power supply. Make sure that the red line is in the direction with positive.

Step 5

This LED strip uses 12V DC, so you can use a 12V DC adapter to this project.

Step 7

Now you can light the sections of under cabinet in your room, or a couple of picture frames on the wall, or whatever you can think of.